Microcontroler based elevator system, Electrical Engineering

Assignment Help:
-micro controller AT89C51
-dc motor
-magnetic sensors
-load sensors

-how to connect all the components? and give me a circuit diagrams

-how to interface all the component with micro controller AT89c51



Related Discussions:- Microcontroler based elevator system

Encoder, decimal to BCD code encoder active low

decimal to BCD code encoder active low

Dc generator, short note on armature reaction

short note on armature reaction

Two stage rc coupled amplifier, Q. Two Stage Rc Coupled Amplifier? ...

Q. Two Stage Rc Coupled Amplifier? It is the most popular type of a multistage amplifier because it is cheap and provides excellent audio fidelity over a wide range of fre

Find the turns ratio of the ideal transformer, Q. Consider an amplifier as ...

Q. Consider an amplifier as a voltage source with an internal resistance of 72 . Find the turns ratio of the ideal transformer such that maximum power is delivered when the amplif

Engineering Science, A rifle with a mass of 3,5 kg fires a bullei with a ma...

A rifle with a mass of 3,5 kg fires a bullei with a mass of 120 g with a muzzle velocity of 420 mls. Calculate the following: 1.4.''l The momentum before the rifle was fired ''1.4.

Measures for improving joints and connection, Measures for Improving Joints...

Measures for Improving Joints and Connection 1. Spacing of poles: The spacing between poles (for overhead lines) is also an important requirement. Long spans will result in

3-phase 180 degree mode vsi , 3-phase 180 0 mode VSI In 1800 mode VSI...

3-phase 180 0 mode VSI In 1800 mode VSI  each thyristor  conduct  for 1800 and two  thyristor  are fired  at 600 interval. For  example  if thyristor  T1  is fired at 00 then

CMA instruction of 8051., if contents of accumulator are all one''s then re...

if contents of accumulator are all one''s then result would be zero so Z flag should be affected and same if all zero''s.....but here it is written that no flags is affected...

Dual trace and dual beam cro, what is difference between dual trace and dua...

what is difference between dual trace and dual beam cro?

Estimate hortons infiltration equation , Show that the infiltration volume ...

Show that the infiltration volume estimated using Horton's infiltration equation between times t1 and t2 is given by; F =f c (t 2 -t 1 )+(f 1 -f c )(1-e -k(t2-t1) )/k Use the

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd