matlab question please help me, Mechanical Engineering

Assignment Help:
The salary calculation method for employees of a company is as follows:
(1) If the number of working hours exceeds 120 hours, an additional 15% will be issued
for the excess part;
(2) If the working hours are less than 60 hours, RMB 700 will be deducted;
(3) The rest will be paid at 84 dollar per hour;
Try programming to calculate the salary payable and display the result according to the
number of hours entered by the employee

Related Discussions:- matlab question please help me

Corollaries of first law of thermodynamics, example of 2nd corollary of fir...

example of 2nd corollary of first law of thermodynamics

Repair of surface defects in welds, Repair of surface defects in welds by c...

Repair of surface defects in welds by chipping, grinding and gouging is permitted provided the thickness is not reduced below the minimum required. Removal of defects shall be ver

Design a cam profile, A cam is required to a lift of 30 mm for a rotation r...

A cam is required to a lift of 30 mm for a rotation range of 60 o . The follower then dwells at this level for a further 90 o and then falls over the next 60 o . Finally the rest

Stress plots, Problem:   The following machine component is loaded as s...

Problem:   The following machine component is loaded as shown.  It is fabricated from Al 6061-T6.   Determine the analytical solution to this problem and compare result

Steps of servicing- important points to remember, The water jet should not ...

The water jet should not directly fall on speedometer, spark plug, steering cone race and electrical connections. During washing there is a possibility of water entry below the sea

Differences between torque and torsion, Differences between torque and tors...

Differences between torque and torsion: Give differences between torque and torsion. List a few examples of torsion in the engineering practice. Sol.: When structural or

What is expansion joints, Q. What is Expansion Joints? Expansion joints...

Q. What is Expansion Joints? Expansion joints are used to accommodate thermal growth in piping and pressure vessel applications. The metal bellows, an integral part of an expan

Determine fraction of the load would cnt fibers carry, Carbon nanotubes (CN...

Carbon nanotubes (CNTs) with low weight (density = 1.3 g/ cm^3), high tensile strength (50 GPa), and modulus of elasticity (1 TPa) in the axial direction have been touted as the st

Find out the smallest force, Find out the smallest force: A block weig...

Find out the smallest force: A block weighing 800 N is raised up with the help of two 6o wedges B and C of negligible weights as illustrated in Figure. If the coefficient of s

Polythionic Acid Stress Corrosion Cracking, In Naphtha Hydrotreating Unit, ...

In Naphtha Hydrotreating Unit, does feed/effluent heat exchangers require passivation to avoid polythionic acid stress corrosion cracking.

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd