Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
MANDATORY CHECKS DURING THE FIRST SIX SERVICES
Various steps in servicing of motorcycle are given below in a tabular form.
2.3.1 First Service and Second Service First Service
Second Service
Sl. No.
Steps of Servicing
1.
Wash the vehicle. Blow, dry with air pressure
2.
3.
Clean fuel strainer
4.
Clean fuel line and fuel strainer
5.
Inspect throttle operation, lubricate if necessary
6.
7.
Clean air filter element
8.
Inspect carburetor, choke and adjust if necessary
9.
Inspect spark plug gap, adjust valve clearance
10.
11.
Replace engine oil
12.
Inspect, clean and adjust the spark plug gap
13.
Check battery, specific gravity and level of the electrolyte and if necessary top up with distilled water
14.
Replace engine oil, top up/replace as required
15.
Clean engine oil filter screen and rotor filter
16.
Inspect engine idle speed and adjust if necessary
17.
Adjust brakes. Inspect for shoe wear/disk pad wear
18.
19.
Check brake light switch function
20.
Inspect and lubricate brake system (brake cam and brake pedal).
Prepare a list and explain the mandatory checks to be carried out during first and second service of a motorcycle.
programming of diesel cycle with a suitable example
State of motion of body change with force: A body on contact with the surface is being pulled along it with the increasing force from zero. How does the state of motion of bo
• IGF Vessel SH: CS + 1.6 mm CA + Internal Coating Eductor: 304L SS or alternatively, 12Cr • ORF Vessel SH: CS + 1.6mm CA + Internal Coating Mixer: 316L SS • Skim Oil T
Determine minimum value of weigh to cause motion: Determine minimum value of weight W required to cause motion of block, which rests on a horizontal plane. The block weighs 3
Elastic Limit: Sol. : When external force acts on the body, the body tends to undergo some deformation. If external force is removed and body comes back to its original shap
The two-storey frame shown in Figure Q4 is such that the self-mass may be considered to be located at the beam levels and the beams may be presumed to be rigid. The self-mass (
Which type of cam is used in general 2 wheelers?and how the type of profile is determined?
Heat Treating Equipment: The major equipment for heat treatment is furnace. There are two main categories of furnaces - batch and continuous. The furnace selection needs cons
assumptions made in deriving a bending formula
a) Consider a brake of your choice and Illustrate self locking and self energizing condition & its significance in brakes design. b) Discuss thermal condition in brake design.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +91-977-207-8620
Phone: +91-977-207-8620
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd