Main dissimilarity among cement plaster and cement render, Civil Engineering

Assignment Help:

Question

What is main dissimilarity among cement plaster, cement render and cement screed? Under what state each of above can be used?


Answer

Purpose of plastering, rendering and screeding is to make a smooth, flat surface to be given finishes like paint, wallpaper and so on.

Plastering is intermediately coating of building resources to be applied on internal facade of concrete walls or blockwalls. Image is intermediate coating for outer walls only. Screeding is coating laid on floors to receive finishes like tiles, carpet, marble etc.

 


Related Discussions:- Main dissimilarity among cement plaster and cement render

How to calculate the combined stresses, Compute the stresses at top and bot...

Compute the stresses at top and bottom fibers in a simply supported pre-stressed concrete beam with a rectangular cross section, 250 mm wide and 450 mm deep, as shown in Figure, at

Shallow foundations, The drainage system of a cantilever wall shown in Figu...

The drainage system of a cantilever wall shown in Figure As 1 became blocked after a heavy rainstorm and the groundwater level, which was originally below the base, rose to1.5 (m)

Roads in deserts, Roads in Deserts: Problems Encountered The ...

Roads in Deserts: Problems Encountered The western portion of Rajasthan is part of the Thar desert, where strong winds below the fine desert sand particles leading to

Stress, stress and there types

stress and there types

Define collisions - underwater inspection of bridge, Define Collisions - Un...

Define Collisions - Underwater Inspection of Bridge? Structural damage to underwater portions of a bridge can either be collision related or direct result of a collision. Colli

Leveling., what is the errors faced in leveling

what is the errors faced in leveling

Mapping, how to understand maps easily?

how to understand maps easily?

Designing water storage tank, Question While designing water storage t...

Question While designing water storage tank , has movement joints be installed? Answer While designing water storage tanks , group joints can be set up in similar w

Determine the allowable bearing pressure of the sand, Two load tests were c...

Two load tests were conducted at a site-one with a 0.5 m square test plate and the other with a 1.0 m square test plate. For a settlement of 25 mm, the loads were found to be 60 kN

Highway Engineering, I am a Civil Engg student. Why CBR Values determined ...

I am a Civil Engg student. Why CBR Values determined only at 2.5 and 5 mm penetration ?.

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd