Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Question
Have air test or water tests be selected to test leakage of constructed gravity pipelines?
Answer
For gravity pipes, air tests are carried out after completion of lying and jointing of pipes. These tests are behaviour to check water tightness of joints and to ensure pipelines are free from harm where leak might occur. Air test has benefit that test itself is easy and faster to be accepted out. It does not need disposal of important quantities of water used in test that is a compulsory requirement for water test. Though, in case leakage survives in constructed segment of gravity pipelines, place of leakage be able to hardly be situated in air test. Furthermore, rate of water leakage cannot be determined from air tests. In adding, air test is gladly affected by atmospheric condition since air has a relatively high coefficient of thermal development. The analysis is as well inclined by moisture state of test pipelines since it affects passage of air through pipelines.
Two load tests were performed at a site-one with a 50 cm square plate and the other with a 75 cm square plate. For a settlement of 15 mm, the loads were recorded as 50 kN and 90 kN
Define Emerging Trends in Bearings? New innovations have taken place in the area of bridge bearings, notable among them are: (1) Shock Transmission Unit (STU) or Lock Up Dev
Calculate the change in volume: If the bar is 1 m long with rectangular cross section of 300 mm deep and 400 mm wide, compute the change in volume of the solid because of a lo
what are tie lines? explain in detail
Joints in Concrete Pavements: Concrete pavements in India are of the jointed plain (unreinforced type). The following types of joints are needed in them : (a) Transverse C
Explain Flow Measurement with Weirs Fixed plates positioned vertically in an open channel over which flow is directed through an opening. The opening linear distance is termed
what type of ethics is environmentel ethics
Compute the stresses at top and bottom fibres in a simply supported pre-stressed concrete beam with a rectangular cross section, 200 mm wide and 400 mm deep at sections A-A, B-B an
types of truss of 15 m cantilever with 1000 kg on free end. May be steel or any lightest material aluminium anodized truss. thanks
Classification of lintels
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: info@expertsmind.com
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd