Magnetic Circuits:, Electrical Engineering

Assignment Help:
A circular ring of magnetic material has a mean length of 1m and a cross sectional area of .001m^2.A sawcut of 5mm width is made in the ring . calculate the magnetizing current required to produce flux of 1m Wb in the air gap if the ring is wound uniformly with a coil of 200 turns.Take relative permeability of the ring material=500.

Related Discussions:- Magnetic Circuits:

Explain isolated i/o scheme, Explain isolated I/O scheme. In I/O mapped...

Explain isolated I/O scheme. In I/O mapped I/O scheme the addresses allocated to memory locations can also be assigned to I/O devices. Because the same address may be assigned

Simulation of a standard ic linear regulator, 1.    Introduction The ob...

1.    Introduction The objective of this assignment is to design and evaluate a stabilised discrete linear power supply. The power supply requires to be designed according to t

Cipper, when i/p voltg is grater than battery diode is clse or open

when i/p voltg is grater than battery diode is clse or open

Give the applications of steel, Give the applications of steel. Steel ...

Give the applications of steel. Steel : It contains iron with a small percentage of carbon added to this. Iron itself is not extremely strong but while carbon is added this as

What is the need of the resistance used in a clipper, Q. What is the need o...

Q. What is the need of the resistance used in a clipper? Resistor is used in a clipper to limit the current through the diode. To avoid the damage due to excessive current thro

Chemistry, Explain the construction and working of a calomel electrode?

Explain the construction and working of a calomel electrode?

Gets parameters data display, On running the simulation, a data display wil...

On running the simulation, a data display will automatically open, similar to that shown in figure. The red circle is the source mismatch stability curve. This will give an indicat

Describe schmitt trigger, a) Describe Schmitt trigger with the help of tran...

a) Describe Schmitt trigger with the help of transfer characteristics. b) Also get the expression of hysteresis voltage VH and output waveform for sinusoidal input signal

The resistance of an electrical conductor, The resistance of an electrical ...

The resistance of an electrical conductor depends on 4 factors, these being:   a)  The length of the conductor   b)  The cross-sectional area of the conductor

Equipment parameter data, Equipment parameter data: The schematic diag...

Equipment parameter data: The schematic diagrams for existing substations have to be prepared along with information of power transformer rating and numbers, impedance values,

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd