Knowledge of science and engineering fundamentals, Electrical Engineering

Assignment Help:

Knowledge of science and engineering fundamentals

Knowledge of basic science and engineering fundamentals is necessary for engineers to develop solution to any complex problem.

There were different specifications related to the project such as controlling the speed of the motor, displaying information on the LCD and communication between remote and receiver. So a program code was needed that initializes all these components and make them work as per the specifications. In order to achieve it, simple MikroC commands were used to initialize the components and C programming codes were used to achieve the functionality.

Before putting all the components together to test the whole circuit each element of the project such as sensor, LCD and H-bridge were tested separately on a breadboard.

 


Related Discussions:- Knowledge of science and engineering fundamentals

Obtain expressions for the in-phase and quadrature component, Q. For DSB an...

Q. For DSB and conventional AM, obtain expressions for the in-phase and quadrature components x d (t) and x q (t), and envelope and phase v(t) and φ(t).

The electrical circuit sign convention, The Electrical Circuit sign convent...

The Electrical Circuit sign convention Notice that current leaves a source at its high potential (positive) terminal but enters a load at its high potential (positive) ter

What is an amplifier, Q. What is an amplifier? What are the various types o...

Q. What is an amplifier? What are the various types of amplifiers? AMPLIFIER: A circuit that increases the amplitude of the given input signal is an amplifier. A small a.c. sig

Calculate the maximum power that transmitted to the load, Calculate the Max...

Calculate the Maximum Power That Transmitted To the Load? A 25 MW load at the 33 kV receiving-end busbar of a short 3-phase transmission line has a power factor of 0.8 lagging.

Characteristics of common source amplifier, Characteristics of Common Sou...

Characteristics of Common Source Amplifier At low frequencies and by using a simplified hybrid-pi model, the following small-signal characteristics can be derived.

Assignment, Hi, I got assignment to design a power electronic system Design...

Hi, I got assignment to design a power electronic system Design the circuit and select the appropriate components for that circuit to fulfil the requirements of the device. Regards

What is transient program area, What is TPA (transient program area)? T...

What is TPA (transient program area)? The memory system is divided in three major parts: transient program area, System is and XMS that is extended memory system.

Calculate voltage and frequency, The stator and rotor of a three-phase, 440...

The stator and rotor of a three-phase, 440-V, 15-hp, 60-Hz, eight-pole, wound-rotor induction motor are both connected in wye and have the following parameters per phase: R1 = 0.5

Wheaton bridge with differential amplifier, when strain gauge design give a...

when strain gauge design give accurate measurement on zero and maximum 999kg but not 500kg

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd