Compute the maximum electromagnetic power, Electrical Engineering

Assignment Help:

Q. A four-pole dc machine with 728 active conductors and 30mWb flux per pole runs at 1800 r/min.

(a) If the armature winding is lap wound, find the voltage induced in the armature, given that the number of parallel paths is equal to the number of poles for lap windings.

(b) If the armature is wave wound, calculate the voltage induced in the armature, given that the number of parallel paths is equal to 2 for
wave windings.

(c) If the lap-wound armature is designed to carry amaximumline current of 100A, compute the maximum electromagnetic power and torque developed by the machine.

(d) If the armature were to be reconnected as wave wound, while limiting per-path current to the same maximum as in part (c), will either the maximum developed power or the torque be changed from that obtained in part (c)?


Related Discussions:- Compute the maximum electromagnetic power

Thevenin equivalent circuit, The circuit below will be most efficiently ana...

The circuit below will be most efficiently analyzed by obtaining the Thevenin equivalent circuit for the circuit to the left of the points (a-b) on the schematic. The capacitor is

Sketch the output waveform for the synchronous counter, Q. Consider a serie...

Q. Consider a series-carry synchronous counter with T flip-flops shown in Figure in which the AND gates carry forward the transitions of the flip-flops, thereby improving the speed

Which are the different fet amplifiers, Q. Which are the different FET ampl...

Q. Which are the different FET amplifiers? A FET can be used as a small-signal amplifier by connecting one of its lead to signal ground. The other two leads then serve as the i

Find the resistance of 1 km of copper cable, Find the resistance of 1 km o...

Find the resistance of 1 km of copper cable having a diameter of 10 mm if the resistivity of copper is 0.017 x 10 -6 Ωm.

FET operation, ON output plot of a JFET n-channel transistor if ID is close...

ON output plot of a JFET n-channel transistor if ID is close to IDSS does the value of VGS close to VP?

Design an integrator, Q. An integrator as shown in Figure is to be designed...

Q. An integrator as shown in Figure is to be designed to solve dy(t) / dt + 2000y (t) = 0 with y(0) = 5. If R i is chosen to be 10 k, find C f .

Pop psw instruction , POP PSW Instruction It is similar to  above pop...

POP PSW Instruction It is similar to  above pop  instruction but instead of normal  register  pairs it uses PSW  as its operand. Program status word  comprises of the content

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd