Inspection and testing for coating application, Mechanical Engineering

Assignment Help:

Q. Inspection and testing for coating application?

The Applicator shall perform all inspection and testing necessary to assure that the surface preparation and coating application comply with the requirements of this specification. All work shall be subject to the OWNER's inspection. The OWNER shall be the final authority on the acceptability of surface preparation and coating application.

The powder manufacturer's representative shall have access to the Applicator's facilities during the progress of the work to undertake any inspection and testing deemed necessary to ensure that the coatings are properly applied.

The Applicator shall keep the records of operating parameters and inspection and test results, and submit such records to OWNER's inspector on a daily basis, for verification. This daily record keeping and submittal to the OWNER's inspector is important to ensure continuing compliance with the specification.


Related Discussions:- Inspection and testing for coating application

Vertical vessels - vessel rigging analysis, Vertical vessels having height-...

Vertical vessels having height-to-diameter ratios greater than 8 and weighing more than 25,000 lb. (11300 kg), shall have bending stresses in the vessel shell/skirt checked, from t

Define cam - application of computers in manufacturing, Define Cam - Applic...

Define Cam - Application of Computers in Manufacturing CAM can be simply defied as "the application of computers in manufacturing." Most elaborately, CAM refers to the use

the entropy change of the universe, Two insulated and identical tanks are ...

Two insulated and identical tanks are filled with nitrogen.  One tank is at 1 bar, 250 o C and the other is at 5 bar, 25 o C.  If the two tanks are connected with a pipe and the v

Ceramics-refractory and abrasive materials, Ceramics, Refractory And Abrasi...

Ceramics, Refractory And Abrasive Materials Introduction There are some situations in practice where high temperatures are occupied. Besides creating that temperatures en

Material selection for insulation, Q. Material Selection for Insulation? ...

Q. Material Selection for Insulation? Material for 15ºC to 650ºC temp range is Calcium Silicate, Manville Thermo-12 or approved equivalent. Material for -18ºC to 230ºC temp.

Show the support locations for truckable skid, Q. Show the support location...

Q. Show the support locations for truckable skid? Unless instructed otherwise by Engineer, support locations for truckable skid shall be determined by skid Vendor. Support loca

Enthalpy - thermodynamics, Enthalpy: Sol: The enthalpy is total ener...

Enthalpy: Sol: The enthalpy is total energy of gaseous system. It takes into consideration, internal energy and pressure, volume effect. Thus, it can be defined as follows:

Belt drive, how will u designate a v belt

how will u designate a v belt

Problems on structural design of combined footings, Problems on Structural ...

Problems on Structural Design of Combined Footings a. Two columns 50 cm x 50 cm in size support service loads of 1200kN and 800kN.The centre to centre spacing between columns

Find out the product of inertia of a rectangular area, Find out the product...

Find out the product of inertia of a rectangular area: Find out the product of inertia of a rectangular area b × d with respect to its sides as illustrated in Figure Solut

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd