Illustrate the principles of operation of centralized, Electrical Engineering

Assignment Help:

Q. Illustrate the principles of operation of centralized SPC and distributed SPC and compare their performance.

Ans:

In centralized control, all control equipment is replaced by a single processor which should be quite powerful. It should be capable of processing 10 to 100 calls per second, depending on load on the system and simultaneously performing many other ancillary tasks. A typical control configuration of an ESS using centralized SPC is displayed in Figure. A centralized SPC configuration may use more than one processor for redundancy purposes there are two approaches to organizing stored program control:

Centralized: In this control, all control equipment is replaced by a single processor which should be quite powerful.

Distributed:In this control, control functions are shared by many processors within exchange itself.


Related Discussions:- Illustrate the principles of operation of centralized

Explain memory mapped i/o scheme for the allocation, Explain Memory Mapped ...

Explain Memory Mapped I/O Scheme. Memory Mapped I/O Scheme: In this scheme there is only one address space. Address space is explained as all possible addresses which microproc

Applied mechanics, State whether Lamis theorem is applicable for more than ...

State whether Lamis theorem is applicable for more than three coplanar concurrent forces?

If a feeder circuit-breaker trips what action is required, Q. If a feeder c...

Q. If a feeder circuit-breaker trips, what action is needed? Ans: First isolate the faulty feeder check the faulty area on which fault the breaker was tripped (open circuit,

Discuss the benefit and limitations of utilizing wind energy, a. Discuss th...

a. Discuss the benefits and limitations of utilizing wind energy for electricity generation. b. Draw the block diagram representation of a thermal power generation unit. Illustr

Digital electronics, Design a 4-bit synchronous counter that has the follow...

Design a 4-bit synchronous counter that has the following sequence: 0 ?4? 9?12 ? 14 ?15 and repeat using: i) JK FF ii)D FF

Switching characteristics during turn off, Switching Characteristics During...

Switching Characteristics During Turn off The techniques  used for turning off a thyristor is known  as  commutation techniques. A  thyristor can be can be  turn off by reducin

Electricity and gas hazards, INTRODUCTION : Electricity is one of the fine...

INTRODUCTION : Electricity is one of the finest gifts of science to the mankind since just a flick of switch can flood the room with light or put on a fan, an air conditioner or a

Types of multiplexing techniques, (a) List three types of Multiplexing tech...

(a) List three types of Multiplexing techniques. (b) Give two advantages of "Multiplexing". (c) Given the total duration for the signal is 8 ns. What is the bit rate for

Sampling methods, The project involves comparisons between di erent samplin...

The project involves comparisons between di erent sampling methods, di erent estimation methods, numerical results using samples selected from a synthetic nite population, and a

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd