Ignition system-electrical system , Mechanical Engineering

Assignment Help:

Ignition System: The ignition system is a source and a means of initial spark required to start burning of fuel. A very high voltage supplied at the spark plug tip causes this spark. It consists of magneto, CDI unit, ignition coil and spark plug. Following are the points of necessity of ignition system :

Means to provide spark for the running of engine.
To minimize the arcing between points.

Related Discussions:- Ignition system-electrical system

Equipment for resistance welding-measurements, EQUIPMENT FOR RESISTANCE WEL...

EQUIPMENT FOR RESISTANCE WELDING-Measurements Measurement of the parameters are important while fixing the parameters or testing a machine. Resistance welding instrumentation s

Calculate values of ki - thick cylinder, Calculate values of KI - thick cyl...

Calculate values of KI - thick cylinder: If cracks of 6 mm and 12 mm length are separately present only one side of inner surface in radial direction find two values of KI.

Ideal fluids in motion, In hydrostatic we consider that fluids were at rest...

In hydrostatic we consider that fluids were at rest. Now we relax this consideration but with caution. We will discuss the flow of an real fluid. There are the assumptions about pe

Iron-carbon phase diagram, Mechanical failure is one of the most important ...

Mechanical failure is one of the most important factors causing component/structure/product no longer fit for its intended purpose. Use examples to explain at least three modes o

I-Section, An unsymmetrical I-Section as shown in figure below. If maximum ...

An unsymmetrical I-Section as shown in figure below. If maximum bending stress is not extend more than 40MPa in the section than find out the moment which it can bear

Applications of spot welding, Applications of spot welding As spot weld...

Applications of spot welding As spot welding can be employed for Al, Cu, Ni and Mg alloys. It is not advisable to spot weld steels with carbon content greater than 0.25 % unles

Calculate stress to cause failure - creep parameters, Calculate stress to c...

Calculate stress to cause failure - Creep Parameters: From creep tests on 713 C alloy the constant C in Larson-Miller parameter is determined as - 85.75. In rupture test a spe

Strength of material and engineering mechanics, Di fferentiate between str...

Di fferentiate between strength of material and engineering mechanics Sol.: Three primary areas of mechanics of solids are statics, dynamics and the strength of materials.

Process planning system, importance of process planning system

importance of process planning system

Different types of layouts, List and explain four different types of layout...

List and explain four different types of layouts for a factory.

Write Your Message!

Name

Email id

Message

Verfication Code

User Account

All Pages