Identify fire hazards - fire risk assessment , Other Engineering

Assignment Help:

Identify fire hazards:

In this part, the process appears to be concentrating on issues that can lead to fire but we have to remember to also consider the presence of a fire within the building as a hazard and we have to identify the worst possible locations for a fire.  The guidance does not make this second part clear but it must be done and, in fact, it is probably the most important part.

 

 

 


Related Discussions:- Identify fire hazards - fire risk assessment

The impact and post-impact behaviour of composites , The Impact and Post-im...

The Impact and Post-impact Behaviour of Composites  Many early studies involved doing Charpy tests on small notched samples. This is a destructive test of impact resistance, co

Abrasive grit, Abrasive Grit This method of compressor cleaning involve...

Abrasive Grit This method of compressor cleaning involves injecting an abrasive grit into the engine at selected power settings ( Figure 21.30.)grit used may be ground walnut s

Oversampling dac, Also called 1-bit DAC or sigma-delta DAC. It uses pulse-...

Also called 1-bit DAC or sigma-delta DAC. It uses pulse-density modulation (PDM) which encodes the signal amplitude by the relative density of the pulses. The output voltage has on

Capital budgeting process, Capital budgeting process: When investing in a l...

Capital budgeting process: When investing in a long term assets, the project has been evaluated in term of its profitability and expected cash flow in the future. The capital budge

Software design principles, explain the design should be traceable to the a...

explain the design should be traceable to the analysis model

Mining, Students are to undertake a tunnel blast design for the following c...

Students are to undertake a tunnel blast design for the following conditions: • Tunnel is 5.5m wide by 5.5.m high • Rock is a granite with a UCS of 300 MPa • Drill hole diameter is

Principles of suveying, the true length of a line is known to be 500m.the ...

the true length of a line is known to be 500m.the line was again measured with a 20m tape and found to be 502m,what is the correct length of the 20m tape.

Accelerated Slipstream, Does the accelerated slipstream create more lift on...

Does the accelerated slipstream create more lift on part of a wing behind the propeller of a multa-engine aircraft? If so, about how much % for an Air King b200? Also the V-22 O

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd