Petroleum Production.., Other Engineering

Assignment Help:
1. . Using the graph of pore/fracture pressure for the Holly Field propose a casing
scheme for the well using the graphical approach. Discuss the suitability of the
selected casing setting depths in relation to the lithology. The wellhead has
three hangers and the final hole size is 81/2".

2.From the information supplied on the graph select a suitable BHA to drill the
final 8 1/2" hole. ( Hint- start by determining a suitable WOB)
Assume 5", 21.87 lb. /ft. drill pipe and determine the value of the suspended
tension load at the top of drill pipe.

will provide the graph for question 2 if you can do it

Related Discussions:- Petroleum Production..

Angle rate systems , Traditionally, seekers have been simple correlation tr...

Traditionally, seekers have been simple correlation trackers and a set of gimbals that are used to measure the angle rates of the target.          - Infrared seekers detect a

Financial engeneering, “A swap bank has to entail certain risks which are i...

“A swap bank has to entail certain risks which are inherent to the swap business and are interrelated” Explain the risks involves in swap business.

Calculating the thrust of the engine - engine performance, Calculating the ...

Calculating the thrust of the engine: When applying the above method to calculate the individual thrust loads on the various components it is assumed that the engine is static.

High level design for an SME network, my course is master in telecommunicat...

my course is master in telecommunication and i need it today is it possible?

Double acting feathering system, Double acting feathering system: To pr...

Double acting feathering system: To prevent excessive drag in the event of a propeller on engine failure, the double acting propeller as with the single acting propeller requir

Swell Factors, The effect of swell factors on volumes

The effect of swell factors on volumes

Permeability of moulding sand, Permeability of Moulding Sand  is the proper...

Permeability of Moulding Sand  is the property of the sand, which permits the gases and steam to escape through the sand mould. For this purpose, the sand must be porous. Permeabil

Components of amplifier, Expertsmind.com brings you unique solution in el...

Expertsmind.com brings you unique solution in electrical engineering RESISTORS: Resistors are designed to drop the amount of voltage going through them, this allow

Fluid cleaning in cold section inspection of aircraft, Fluid Cleaning T...

Fluid Cleaning This procedure involves spraying an emulsive type surface cleaning fluid into the compressor whilst the engine is turning either on the starter motor or at low R

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd