How to configure a wireless mac filter - ccna, Computer Networking

Assignment Help:

Configure a Wireless MAC Filter

Step: Add a Mac filter.

  • Navigate back to the web utility page of the router (https://172.17.30.1).
  • Navigate to the Wireless section and then to the Wireless MAC Filter tab.
  • Check Enabled.
  • Select Prevent PCs listed below from accessing the wireless network.
  • Enter the MAC address 00:05:4E:49:64:87.

This prevents any client with the MAC address 00:05:4E:49:64:87 from accessing the wireless network.

 


Related Discussions:- How to configure a wireless mac filter - ccna

What are the trends in network security, Q. What are the trends in Network ...

Q. What are the trends in Network Security ? Trends in Network Security Improved vigilance for virus infections Continual maturation of firewall technologies

Find out the amplitude of the voltage, Questions: A signal of amplitude...

Questions: A signal of amplitude 10 mV is fed to the amplifier in the figure. What is the amplitude of the voltage at the output from the amplifier?

Types of redundancy checks, Types of Redundancy Checks Parity Check ...

Types of Redundancy Checks Parity Check Simple Parity Check Two Dimensional Parity Check / Longitudinal Redundancy Check (LRC) CRC (Cyclic Redundancy Check)

Operating system for server, Operating system for Server Since 1994, w...

Operating system for Server Since 1994, when the original pair of web servers - NCSA HTTPd and CERN HTTPd , were proposed, dozens of commercial and shareware programs have

State the process of calculate the drift rate, State the process of calcula...

State the process of calculate the drift rate A drift rate of 10 -9 means 1 second in 109 seconds or 1 nsec every second. At OC-1 speed, say 50 Mbps for simplicity, a bit las

Construct with private and firstprivate clauses, In this example we will se...

In this example we will see the use of parallel construct with private and firstprivate clauses. At the end of the program i and j remain undefined as these are private to thread i

Configure the management interface- spanning tree protocol, Configure the m...

Configure the management interface address on all three switches.  S1(config)#interface vlan1 S1(config-if)#ip address 172.17.10.1 255.255.255.0 S1(config-if)#no shutdown

What are called transactions, The grouped SQL statements are known as Trans...

The grouped SQL statements are known as Transactions (or) A transaction is a collection of actions embused with ACID properties.

What are super servers, These are fully-loaded machines which consists of m...

These are fully-loaded machines which consists of multiprocessors, high-speed disk arrays for interview I/O and fault tolerant features.

Ipv6 packet format - network layer and routing , IPv6 packet Format Th...

IPv6 packet Format The format  of an IPv6 header is shown  in figure. Although IPv6 addresses are four  times  the size  of IPv4 address  the basic  IPv6 header is only twice

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd