half wave rectifier connected to a dc motor, Electrical Engineering

Assignment Help:
Ask questiwe have half wave rectifier connected to a dc motor load. by using a step down transformer from 8 to 1. by modalization we have the Primary Winding resistance is Rp=50 ohm and it''s Lp=0.1 H the second Winding resistance is Rs=0.3 ohm and it''s Ls=1 mH , the diod open at 0.55 volte and its resistance is Rd=0.15 ohm, the DC Motor have a serial resistance ra=0.15 ohm and a serial La=150mH. we have E=20 V. find the current Io. find the largest E value witch make the diod connect during all the role period. find the mean value of Io in this case. what happen when we reduce E value. what happen in the transformer.on #Minimum 100 words accepted#

Related Discussions:- half wave rectifier connected to a dc motor

Determine the current flow, Q. A charge q(t) = 50 + 1.0t C flows into an el...

Q. A charge q(t) = 50 + 1.0t C flows into an electric component. Find the current flow.

Conditions in which rc circuit behaves as integrator, Q. Explain the condit...

Q. Explain the conditions under which an RC circuit behaves as Integrator? Integrator is a circuit in which the output voltage is proportional to the integral of the input. Out

Transistor hybrid model, Transistor Hybrid model:- Make Use of h - par...

Transistor Hybrid model:- Make Use of h - parameters to explain a transistor have the following benefits. a)      h - Parameters are real numbers that are up to radio frequ

Properties and application of permanent magnetic materials, Give the proper...

Give the properties and application of permanent magnetic materials. Permanent magnetic materials: Properties: Permanent magnetic materials have a huge area of hyster

Student, Can I get some ideas for power system stability simulation using M...

Can I get some ideas for power system stability simulation using Matlab?

Differentiate between a clamper and clipper, Q. What is a clamper? Differen...

Q. What is a clamper? Differentiate between a clamper and clipper. Clamping network shifts (clamps) a signal to a different dc level, i.e. it introduces a dc level to an ac sig

Calculate terminal voltage, A permanent magnet DC motor is being considered...

A permanent magnet DC motor is being considered for use as a drive motor for a vehicle. The motor is known to have the following properties No load speed @ 100 V = 2000 rpm torq

What do you mean by inaccessible area coverage, Q. What do you mean by Inac...

Q. What do you mean by Inaccessible area coverage? Marshy lands, hilly areas, etc where ground surveys could be very difficult, remote sensing technique can provide reliable an

Show that any periodic signal is not typically energy type, (a) Evaluate wh...

(a) Evaluate whether the sinusoidal signal x(t) = A cos (2πf 0 t + θ) is an energy-type or a power-type signal. (b) Show that any periodic signal is not typically energy type, a

Compute the firing angle for the rated braking torque, Consider a 3-hp, 220...

Consider a 3-hp, 220-V, 1800-r/min separately excited dcmotor controlled by a single-phase fully controlled rectifierwith an ac source voltage of 230Vat 60Hz.Assume that the full-l

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd