Global positioning system, Electrical Engineering

Assignment Help:

Global Positioning System:

For power utilities, the basic objective of using Global Positioning System (GPS) and GIS should be to:

enhance the efficiency of transmission/distribution system in terms of quality of power;
increase revenue earning;
decrease T&D losses (both technical and commercial) as well as outages; and
combine the functions of independent offices into the mainstream operational hierarchy with the help of organisation-wide networking.

Related Discussions:- Global positioning system

Transfer characteristics , Transfer Characteristics The transfer char...

Transfer Characteristics The transfer characteristics of power MOSFET transfer characteristic shown the variation of ID with V GS denote the drain current with shorted

Define addressing modes of 8085, Define addressing modes of 8085. a) Im...

Define addressing modes of 8085. a) Immediate addressing b) Register addressing c) Direct addressing d) Indirect addressing e) Implicit addressing

Digital electronics logic family, For a given logic family, consider VOL = ...

For a given logic family, consider VOL = 0.25V and VOH = 5 V . For a given circuit, VIL = 0.96 V and VIH = 2.18 V. Find the largest positive-going and largest negative-going nois

Determine voltage - current and the power, Q. Determine v, i, and the power...

Q. Determine v, i, and the power delivered to elements in the network given in Figure. Check whether conservation of power is satisfied by the circuit.

Slack running fit, Illustrate the conventional representations of the follo...

Illustrate the conventional representations of the following guide to the selection of Fits: (i) Slack Running Fit (ii) Loose Running Fit (iii) Easy Running Fit (iv) No

Assingment, #question.help.

#question.help.

Speed control of dc motor - motor control , Speed control of DC Motor ...

Speed control of DC Motor The DC motor are versatile motors among the available electrical motors due to their superior characteristics. These motors give a smooth sp

Spread time - power semiconductor devices , Spread Time (t s ) During ...

Spread Time (t s ) During spread time anode voltage falls from 10% I a to the on state voltage drop and anode current rises from 90% I a to final value of anode

Electric Drive, project to write a program to simulate a dc motor on a matl...

project to write a program to simulate a dc motor on a matlab

Sr flip flop - introduction to microprocessors , SR Flip Flop The SR f...

SR Flip Flop The SR flip flop is an arrangement of logic gates that maintain astable output even after the input are turned off. It has two inputs namely SET input (S

Write Your Message!

Name

Email id

Message

Verfication Code

User Account

All Pages