Explain the signals hold and sid, Electrical Engineering

Assignment Help:

Explain the signals HOLD, READY and SID

HOLD indicates that a peripheral such as DMA controller is requesting the use of address bus, data bus and control bus. READY is used to delay the microprocessor read or write cycles unless a slow responding peripheral is ready to send or accept data. SID is used to accept serial data bit by bit

 


Related Discussions:- Explain the signals hold and sid

Chemistry, Write short note on hardness of water and its units

Write short note on hardness of water and its units

Obtain an expression for the closed-loop transfer function, Q. A noninverti...

Q. A noninverting op-amp circuit and its closed-loop representation are given in Figure. Obtain an expression for the closed-loop transfer function H(ω) = Y (ω)/X(ω) and comment on

Determine the electromagnetic power, A dc shunt motor runs off a constant 2...

A dc shunt motor runs off a constant 200-V supply. The armaturewinding resistance is 0.4, and the ?eld winding resistance is 100 . When the motor develops rated torque, it draws

Explain working of single-phase induction motors, Q. Explain working of Sin...

Q. Explain working of Single-Phase Induction Motors? For reasons of simplicity and cost, a single-phase power supply is universally preferred for fractional-horsepower motors.

Transformer, What is the difference between primary and secondary winding o...

What is the difference between primary and secondary winding of transforme

What is the signal classification of 8085, What is the signal classificatio...

What is the signal classification of 8085 All the signals of 8085 can be classified into 6 groups Address bus Data bus Control and status signals Power supply and f

What do you understand by progressive control, Q. What do you understand by...

Q. What do you understand by progressive control? Progressive Control: Step by step system is an example of progressive control. The connection is set up in stages, in response

Value of current if resistance connected to the battery, One battery having...

One battery having of eight cells in parallel. Emf and internal resistance of every cells is 1.5V and 0.4Ω. Find the value of current if an external resistance of 5Ω is connected t

Background of energy conservation, Background of Energy Conservation ...

Background of Energy Conservation As a thumb rule, the energy needs of a country are about 1.5 times its GDP or the economic growth rate. India's projected growth rate up to

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd