Give the properties and application of cotton, Electrical Engineering

Assignment Help:

Give the properties and application of cotton.

Cotton: It is base material for insulating fibres.

Properties:

It can be enhanced by impregnating with varnish.

1) Cotton is hygroscopic. Moisture absorption is 70 percent.

2) Cotton has low dielectric strength.

3) Resistivity of cotton changes with moisture content.

4) Cotton can be used up to 1100C.

5) Density of cotton is 1.54gm/cm3.

Applications: Cotton is used as insulating material for armature winding of small as well as medium sized machines, small transformers, chokes and coils. It covered wires are used for winding of small magnet coils.


Related Discussions:- Give the properties and application of cotton

Show block diagram of a 4-bit parallel-input shift register, Q. Show a bloc...

Q. Show a block diagram of a 4-bit, parallel-input shift-right register and brie?y explain its operation.

Motor windings, What is the main function of dummy coul in winding?

What is the main function of dummy coul in winding?

Why biasing in necessary in transistor, (a) Describe why ordinary junction ...

(a) Describe why ordinary junction transistor is known as bipolar. (b) Describe working of NPN transistor as common Base configuration. Describe working of NPN transistor in

Find the corresponding change ib in the base current, Q. Using the small-s...

Q. Using the small-signal equivalent circuit of a BJT with gm = 0.03 S, β = 75, and VA = 65 V, a load resistor RL is connected from the collector to the emitter, as shown in Figure

Describe the design procedure of oai 321 cell at transistor, Obtain express...

Obtain expressions for the drain source current in an n-channel MOS transistor in terms of terminal voltages and transistor parameters. Indicate reasons why, for deep sub micron t

Computer-aided circuit analysis using MATLAB, Q. Computer-aided circuit ana...

Q. Computer-aided circuit analysis using MATLAB ? This text does not teach MATLAB; it assumes that the student is familiar with it through previous work. Also, the book does no

Compare dispersion effects single mode and multimode fibre, Compare dispers...

Compare dispersion effects in single mode and multimode fibres? The optical fibres were categorized within two according to the number of modes it passes as: • Single mode fibre

Give the classification of oscillators, Q. Give the classification of Oscil...

Q. Give the classification of Oscillators?  Depending on the type of the output waveform, oscillators are classified as sinusoidal (or harmonic) oscillators and relaxation osci

Resetin input - externally initiated signals , RESETIN  Input It is a...

RESETIN  Input It is an  active  low signal when  it goes low program counter is  reset to zero and busses are tri stated  it also reset interrupt enable flip flop  and instruc

Find the current flow through a resistor, Q. Find the current flow through ...

Q. Find the current flow through a resistor ? Consider the circuit shown in Figure (a). Reduce the portion of the circuit to the left of terminals a-b to (a) a Thévenin equival

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd