Give the principle of biasing a fet amplifier, Electrical Engineering

Assignment Help:

Q. Give the principle of biasing a FET amplifier.

To correctly bias the FET, the gate needs to be negative with respect to the source. Bias is obtained in the following manner:

Drain current flows through the source resistor and develops a voltage across it, making the emitter positive with respect to the zero volts rail. There is no gate current, so there is no current through the gate resistor. This means that there is no voltage across this resistor so it will be zero volts at both ends. This means that there is zero volt on the gate. Therefore the source is positive with respect to the gate. The gate is negative with respect to the source. The fet is biased correctly. When a signal voltage is applied to the gate, it controls drain current. When the signal goes more negative the drain current is reduced and voltage across drain resistor is less. The drain voltage goes more positive. When the signal goes less negative the drain current is increased and the voltage across the drain resistor is more. The drain voltage goes less positive. In both cases, the drain voltage does the opposite of gate voltage.


Related Discussions:- Give the principle of biasing a fet amplifier

Diode characteristic, Q. For the circuit shown in Figure(a), determine the ...

Q. For the circuit shown in Figure(a), determine the diode current and voltage and the power delivered by the voltage source. The diode characteristic is given in Figure.

Thunderstrom detector, Ask question #how to construct thunderstrom detector...

Ask question #how to construct thunderstrom detector with circuit breaker.

Problem of current electricity, charges of +2q and -4q are fixed a distance...

charges of +2q and -4q are fixed a distance d apart as in figure_2(a).find electric field at the point A ,B and C (b) sketch roughly the electric field lines.

What are the important requirements of a insulating material, What are the ...

What are the important requirements of a good insulating material? Important requirements of good insulating materials:- The necessity of good insulating materials can be cl

Find the frequency domain characteristics, This question is about linear fi...

This question is about linear filtering concepts using the built in filtering functions (it is not about edge detection methods). Load the MRI image of Q4 above and perform the

atex equipment, I have an enclosure which doesnt comply with the atex dire...

I have an enclosure which doesnt comply with the atex directive, they want to install it in outside in a safe area of an offshore platform. They have produced an atex cert and want

Compute the worst voltage regulation, Q. The following data were obtained o...

Q. The following data were obtained on a 25- kVA, 2400:240-V, 60-Hz, single-phase distribution transformer: • Open-circuit test with meters on LV side: 240 V, 3.2 A, 165 W •

Diffrentiate between Brass and Bronze, Explain Brass and Bronze. Brass...

Explain Brass and Bronze. Brass - It is an alloy of copper and zinc with 60 percent copper and 40 percent zinc. Its electrical resistivity of Brass is 7.0 X 10 -8 ohm-m th

What is positive clipper, Q. What is positive clipper? Give 2 types of its ...

Q. What is positive clipper? Give 2 types of its applications ? In the series positive clipper, when the input voltage is positive, the diode does not conduct and acts an open

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd