General factors behind accidents , Mechanical Engineering

Assignment Help:

GENERAL FACTORS BEHIND ACCIDENT: Following are the factors, which may cause accidents in workshop, so we should take care of these factors:

  • Insufficient light and ventilation at workplace.
  • Restricted available tool.
  • Use of prohibited items.
  • Lack of concentration, confidence.
  • Lack of motivation, honesty.

 


Related Discussions:- General factors behind accidents

Calculate the closed loop transfer function, Draw schematic diagram of a po...

Draw schematic diagram of a position control system using armature controlled DC Servo motor. Graph the signal flow graph and hence calculate the closed loop transfer function.

CRANK SHAFT, TO FIND THE MAGNITUDE OF CRANK SHAFT

TO FIND THE MAGNITUDE OF CRANK SHAFT

Tachometer-electrical instruments , Tachometer: This is used to measure th...

Tachometer: This is used to measure the speed (revolutions) of an engine in revolutions per minute (RPM). This is shown in Figure. Figure : Tachometer

TTT of effective normalizing of Ductile tiron, At 1500 degrees F, how much ...

At 1500 degrees F, how much time is required to effectively normalize ductile iron

Feedwater controls for steam generator, Q. Feedwater Controls for Steam gen...

Q. Feedwater Controls for Steam generator? associated with that Steam Generator. The flow controllers utilize regular P.I.D. controllers, and their outputs are fed directly to

Thermodynamics, Problem specification 5 kg of air is contained in a piston-...

Problem specification 5 kg of air is contained in a piston-cylinder device, initially at a pressure of 2MPa and a specific volume of 0.08m3/kg. The air then expands, as an ideal ga

Gas turbine, what is the affect of ambient temperature on the performance o...

what is the affect of ambient temperature on the performance of GAS turbine

Cutting test, Cutting Test:             Once the sand blasted blade we...

Cutting Test:             Once the sand blasted blade were went through the washing process. Quality Control technician will randomly pick 15 pieces of blade to go for cutting

Design an evaporator system, Q. Design an Evaporator System? The Evapor...

Q. Design an Evaporator System? The Evaporator System is designed to produce high quality distillate. The feed water to the evaporator system is dosed with antiscalant and rece

Flash butt welding, Flash Butt Welding This process is an extension of ...

Flash Butt Welding This process is an extension of resistance butt welding. The parts to be joined are gripped in the clamps and their interfaces are gradually brought into con

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd