FRACTIONAL PID TUING USING GA FOR LOAD FREQUENCY CONTROL, Electrical Engineering

Assignment Help:
Iam doing my project on LFC using tuned FOPID.I have considered a two area model..I need help regarding my project.i need help regarding implementation of GA MATLAB code for a two area interconnected power system for LOAD FREQUENCY CONTROL. I have created simulation model for the same and getting the output after PID Implementation. Now in order to decrease the overshoot and settling time of the output wave of PID I need to implement the GA technique to get the optimized result.I want to know whether you can take up this project and also the deal.

Related Discussions:- FRACTIONAL PID TUING USING GA FOR LOAD FREQUENCY CONTROL

Find the inductor current and voltage, Q. The energy stored in a 2-µH induc...

Q. The energy stored in a 2-µH inductor is given by wL(t) = 9e-2t µJ for t ≥ 0. Find the inductor current and voltage at t = 1 s.

How DRAM is different from SRAM, How DRAM's are different from SRAM's?  Why...

How DRAM's are different from SRAM's?  Why DRAMs are said to employ address multiplexing? Dynamic RAM (DRAM) is fundamentally similar as SRAM, except that this retains data for

Chopper configuration - power supplies , Chopper Configuration Choppe...

Chopper Configuration Chopper are classified  in five  different classes according  to their operating capability in particular quadrant. The  current  directions and voltage

What do you mean by digital building blocks, Q. What do you mean by Digital...

Q. What do you mean by Digital Building Blocks? Whereas a continuous change from one value to another is the essential characteristic of an analog signal and continuous-state (

Determine the maximum value of the voltage, Q. Three waveforms seen on an o...

Q. Three waveforms seen on an oscilloscope are shown in Figure. If the horizontal scale is set to 50 ms per division (500 ms for the entire screen width), and the vertical scale is

Comperators, How to build a 6 bit comparator?

How to build a 6 bit comparator?

Modify the jk flip-flop to operate like the t flip-flop, Q. A JK flip-flop ...

Q. A JK flip-flop is shown in Figure (a). (a) Modify it to operate like the D flip-flop of Figure (b). (b) Modify the JK flip-flop to operate like the T flip-flop of Figure (

Determine the required value of the flux density, Q. A 100-turn coil in the...

Q. A 100-turn coil in the configuration of is rotated at a constant speed of 1200 r/min in a magnetic field. The rms induced voltage across the coil is 1 kV, and each turn has a le

Determine excitation voltage and power angle, A 500KVA, 6 pole, 500v, 3 pha...

A 500KVA, 6 pole, 500v, 3 phase, wye-connected synchronous generator has a synchronous impedance of 0.1 + j1.5 ohms per phase. If the generator is driven at 1000 r.p.m., what is th

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd