Fourth gear position - shifting of gear, Mechanical Engineering

Assignment Help:

Fourth Gear Position: When gear M4 on the main shaft is in mesh with gear C4 on the countershaft then this is known as fourth gear position. The free gear M4 rotates with the main shaft by bringing M3 in its contact by sliding M3. Thus, C4 will turn causing countershaft to rotate.

 


Related Discussions:- Fourth gear position - shifting of gear

Dry saturated steam - thermodynamics, Dry Saturated Steam - thermodynamics:...

Dry Saturated Steam - thermodynamics: A dry saturated steam is single phase medium. It does not have any water particle. It can be obtained on complete evaporation of water at

Develop-implement method to identify numerically equivalent, For example, i...

For example, if one were provided with the set [3 1 3 -4 -6], the resulting answers would be [3 1 -4], [3 1 -4], an [3 3 -6], as these are the three sets of three values which sum

Determine the location of the hydraulic jump, A rectangular channel of widt...

A rectangular channel of width 12ft has an upstream slope of 0.02ft/ft and a downstream slope of 0.0005 ft/ft. Both reaches have lengths of 500 ft. The upstream reach has a Manning

Stress analysis requirements, Q. Stress analysis requirements? All othe...

Q. Stress analysis requirements? All other lines requiring review by the stress group are to be checked for adequate support, stability, excessive movement, etc. Where hand ca

Write down the uses of vernier caliper and steel rule tools, Write down the...

Write down the uses of following tools and make neat sketches of the same : (a) Vernier Caliper (b) Steel Rule

Need it fast, PROBLEM 1 (30 points) Consider a Boeing 747-400 at weight clo...

PROBLEM 1 (30 points) Consider a Boeing 747-400 at weight close to the maximum takeo? weight (MTOW) cruising at Mach 0.82 at an altitude of 32000 ft. (a) How much thrust is needed

Steady state temperature, Is it possible for the steady state temperature p...

Is it possible for the steady state temperature profile in a plane wall to be nonlinear at steady state? If yes, provide one example. Solution: Steady state temperature profile

Explain about hardness testing, Q. Explain about Hardness testing? When...

Q. Explain about Hardness testing? When indicated on equipment or vessel data sheets, hardness testing shall be performed as follows: a) Perform hardness tests at or near th

Thermophyics, The steam that leaves the super-heater is expanded from 130ba...

The steam that leaves the super-heater is expanded from 130bar at 535°C to 25.2bar at 310°C in a high pressure turbine. The steam from the exit of the HP turbine is reheated to 535

Condenser capacitor electricity , Condenser ( Capacitor ) : A capacitor i...

Condenser ( Capacitor ) : A capacitor is used to store the electrical energy. The maximum value of stored energy depends on its capacity. It helps to achieve required high voltag

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd