Flange assembly with torque measurement, Mechanical Engineering

Assignment Help:

Q. Flange Assembly with Torque Measurement?

Select the proper bolts and gasket for the intended service. Use only new, undamaged gaskets.

Lubricate the bolt threads and nut bearing surfaces.

Install two bolts diametrically opposite each other, and one bolt halfway between the previously installed bolts for retaining the position of the gasket.

Insert the gasket and center it in the flange. Hand tighten the nuts to hold the gasket in place.

Install the remaining bolts and nuts. Hand tighten the nuts keeping the flange faces parallel. Take care to assure proper seating and centering of the gasket and all the nut threads are fully engaged. Longer stud bolts should be used if all the nut threads are not fully engaged.

Number and mark the bolts with the pattern described below in a clockwise direction around the flange starting at the top (12 o'clock).


Related Discussions:- Flange assembly with torque measurement

Safety considerations for storage tanks, Q. Safety considerations for stora...

Q. Safety considerations for storage tanks? Large storage tanks are potential fire hazards and should be located at a lower elevation than other occupancies to prevent liquids

Heat transfer and temperature distribution, Derive the mathematical express...

Derive the mathematical expression for heat transfer and temperature distribution through infinite long fin?

Electrodes- cast iron electrodes, Cast Iron Electrodes There are three ty...

Cast Iron Electrodes There are three types of electrodes for welding of cast ions. a) Monel-cored electrodes (30 % Ni 70 % Cu) b) Fe-Ni (40 % Ni) c) Ni-electrodes (97 E) These

Show the tensile properties of material, Q. Show the tensile properties of ...

Q. Show the tensile properties of material? Tensile properties indicate how the material will react to forces being applied in tension. A tensile test is a fundamental mechanic

Evaluate the total deformation of the bar, (a) A member ABC is formed by co...

(a) A member ABC is formed by connecting a steel bar of 20mm diameter to an aluminium bar of 30 mm diameter, and is subjected to forces as shown in figure. Evaluate the total defor

Insulatlon application information, The Contractor shall perform all work w...

The Contractor shall perform all work with the highest quality workmanship throughout to provide a neat, uniform appearance with no sharp edges exposed. Insulation shall not be

Asset utilization, Asset Utilization: The data listed in Tables 1 and ...

Asset Utilization: The data listed in Tables 1 and 2 provide information about M/S Forge Private Limited. Table: Annual Balance Sheet with Partial Information

Explain types of gas welding process, Types of Gas Welding Process Gas ...

Types of Gas Welding Process Gas welding includes all those welding processes in which gas flame is used as a heat source for melting metals. It is further divided into three m

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd