Find the total line current flowing through feeder, Electrical Engineering

Assignment Help:

Q. Athree-phase, 60-Hz substation bus supplies two wye-connected loads that are connected in parallel through a three-phase feeder that has a per phase impedance of 0.5 + j2 . Load 1 draws 50 kW at 0.866 lagging PF, and load 2 draws 36 kVA at 0.9 leading PF. If the line-to-line voltage at the load terminals is 460 V, find the following:

(a) Total line current flowing through the feeder.

(b) Per-phase impedance of each load.

(c) Line-to-line voltage at the substation bus.

(d) Total real and reactive power delivered by the bus.


Related Discussions:- Find the total line current flowing through feeder

Ujt as a relaxation oscillator , UJT as a  relaxation  oscillator Th...

UJT as a  relaxation  oscillator The UJT  is a highly  efficient  switch  it is  used as trigger  a device for SCR. No sinusoidal oscillators saw tooth generators phase contro

Relative and absolute motion measuring device, a) With the help of a neat a...

a) With the help of a neat and clean sketch illustrate the difference between relative and absolute motion measuring device. b) Discuss electromechanical methods for calculating

Explain amplitude-shift keying, Q. Explain Amplitude-shift keying? A ca...

Q. Explain Amplitude-shift keying? A carrier's amplitude is keyed between two levels (binary 1 and 0) in binary ASK. Figure shows the functions of a coherent ASK communication

Low pressure gas hazards, Low Pressure Gas Hazards : Safety screens and wi...

Low Pressure Gas Hazards : Safety screens and wire-mesh guards should be placed round evacuated glassware and safety goggles or a face shield must be worn against the possibility

Depletion in mosfert, #Minimum 100 words accepted#explain depletion operati...

#Minimum 100 words accepted#explain depletion operations of MOSFET

Frequency stability of quartz crystals, Q. Frequency stability of quartz cr...

Q. Frequency stability of quartz crystals ? The amount of frequency deviation from the ambient temperature frequency over the operating temperature range. This deviation is ass

Compute the maximum value of the voltage induced in the coil, Q. The coil i...

Q. The coil is placed so that its axis of revolution is perpendicular to a uniform field, as shown in Figure If the flux per pole is 0.02 Wb, and the coil, consisting of 2 turns, i

Find the total current and total resistance, For the circuit in figure, fin...

For the circuit in figure, find: a)  Total resistance b)  Total current c)  Current flow through resistor 6Ω and 4Ω

amplitude modulated waveform, The method by which electrical signals conve...

The method by which electrical signals convey information has been described. Systems components have been selected and interfaced to enable a chosen system to perform a desired o

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd