Find the time domain equivalent sinusoid, Mechanical Engineering

Assignment Help:

Given these sinusoids: x1(t) = 0.5cos(25t+20o),   x2(t)=0.85cos(25t+160o) and   x3(t)= 0.81cos(25t-145o)

(a) Subplot the phasors X1, X2 and X3 corresponding to the thee sinusoidal signals at time t=0 seconds and on the same subplot, show the sum of the phasors X = X1+X2+X3.

(b) On a second subplot, plot the phasor positions of  X1, X2, X3 and X at t=0.04 seconds. How much phase change in degrees does 0.04 seconds correspond to?

(c) Comment on the relative position of the phasors X1, X2 and X3 on the two plots and annotate plot to indicate how much they have changed position. Use MATLAB to find the amount of rotation.

(d) On a third subplot, find the time domain equivalent sinusoid of the phasor sum Y= X1+(- X2) + X3.

At what time t0 will the phasor Y first lie on the positive real axis?

(e) Submit the plot and source code with any pertinent MATLAB output clearly annotated.


Related Discussions:- Find the time domain equivalent sinusoid

Sand blasting handling method, Sand blasting handling method:        ...

Sand blasting handling method:             On last experiment we had decided to use 3.0 bars as it shown better result. Now we had to investigate the sand blasting handling

Influence lines for the force, Solve the following two questions of the tru...

Solve the following two questions of the truss. Note that A and G are pin supports.  1)  Sketch the influence lines for the force in bar DG (the load is moving on the top chord

Determine the principal stresses and angle, A "perfect" square (shown in da...

A "perfect" square (shown in dashed lines in the sketch below) with initial dimensions of 0.5 x 0.5 inch is drawn on the surface of a thin aluminum structure (E = 10x10 6 psi, v =

MOS, limitations of euler''s theory

limitations of euler''s theory

Find speed of dynamo shaft, Find speed of dynamo shaft: Q: W ith the...

Find speed of dynamo shaft: Q: W ith the help of belt an engine running at 200rpm drives line shaft. The Diameter of the pulley on engine is 80cm and the diameter of the pul

Determine minimum value of weigh to cause motion, Determine minimum value o...

Determine minimum value of weigh to cause motion: Determine minimum value of weight W required to cause motion of block, which rests on a horizontal plane. The block weighs 3

Bearing materials, Bearing Materials Generally it can be said as a good...

Bearing Materials Generally it can be said as a good bearing material must posse following characteristics as: It must be strong enough to sustain bearing load. It

Calculate power factor of the heating element, A single phase series resist...

A single phase series resistive-inductive heating element draws a measured current of 15A when connected to a 225V single phase 50 Hz AC supply. Tests have shown that a minimum

Define the primitives of b-rep scheme, Primitives of b-rep Scheme The b...

Primitives of b-rep Scheme The building blocks for b-rep. models are : Vertex It is a unique point (an ordered triplet) in space. Edge An edge is a finite, non-

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd