Explain cutting speed-material removal rate & machining time, Mechanical Engineering

Assignment Help:

Determine- cutting speed, Material removal rate and Machining time.

A 150 mm long 12.7 mm diameter stainless steel rod is being turned to 12.19 mm diameter on a centre lathe. Spindle speed = 400 rev./min. Axial speed = 203.20 mm/min.


Related Discussions:- Explain cutting speed-material removal rate & machining time

Factor of safety - working stress, Factor of Safety: Factor of saf...

Factor of Safety: Factor of safety is number used to determine working stress. It is fixed based on experimental works on material. It accounts all uncertainties like, mate

Driveshaft design, The  impeller driveshaft  can either be top driven or bo...

The  impeller driveshaft  can either be top driven or bottom driven. Again there are advantages of each and the choice often varies with scale of operation: (a) Top driven (labo

Determine the slopes at free end - cantilever beam, Determine the slopes at...

Determine the slopes at free end - cantilever beam: A cantilever beam of length l carries a point load W at a distance l  /4 from free end. Determine the slopes at free end

Briefly explain transient response for various input signals, Briefly Expla...

Briefly Explain transient response for various input signals - unit step input - unit parabolic function - unit ramp function - impulse function

Heat faster steel copper or brass, Which conducts heat faster steel copper ...

Which conducts heat faster steel copper or brass? Ans) Copper conducts heat faster than steel or brass. Any material that is good for conducting heat is also good for electricit

Carburettor cleaning of motorcycle, Carburettor Cleaning:  Carburettor nee...

Carburettor Cleaning:  Carburettor needs to be cleaned otherwise the jets may get clogged which may supply an inadequate amount of air fuel mixture. Inadequate amount of air fuel

Consideration for centrifugal tension, Consideration: 1. From above eq...

Consideration: 1. From above equation, it is clear that centrifugal tension is not dependent of T1 and T2. It depends upon velocity of the belt. For lower belt speed (that is,

Mechanics, definition of open and cross belt drive

definition of open and cross belt drive

I want assignment on types of suspension systems, It should include 10 page...

It should include 10 pages along with pictures and references.

Change in gravitational force, prove that the weight of a body at an elevat...

prove that the weight of a body at an elevation of h from sea level is expressd by the equation

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd