Find the efficiency of the transformer, Electrical Engineering

Assignment Help:

Q. A three-phase, 600-kVA, 2300:230-V,Y-Y trans-former bank has an iron loss of 4400Wand a full-load copper loss of 7600 W. Find the efficiency of the transformer for 70%full load at 230 V and 0.85 power factor.


Related Discussions:- Find the efficiency of the transformer

Open-circuit and load characteristics of generator, Q. Open-circuit and loa...

Q. Open-circuit and load characteristics of generator? The open-circuit and load characteristics of a separately excited dc generator, along with its schematic diagram of conne

Characteristics of common source amplifier, Characteristics of Common Sou...

Characteristics of Common Source Amplifier At low frequencies and by using a simplified hybrid-pi model, the following small-signal characteristics can be derived.

What is meant by thermal runaway, Q. What is meant by Thermal Runaway? Expl...

Q. What is meant by Thermal Runaway? Explain with reference to a transistor.How is it avoided in circuits? The collector current of a transistor increases with increasing tempe

Why do we cascade amplifiers, Q. Why do we cascade amplifiers? Why is RC co...

Q. Why do we cascade amplifiers? Why is RC coupling the most widely used coupling between 2 stages of a cascading amplifier? The voltage or power gain or frequency response obt

Student, Can I get some ideas for power system stability simulation using M...

Can I get some ideas for power system stability simulation using Matlab?

Magnetic Circuits:, A circular ring of magnetic material has a mean length ...

A circular ring of magnetic material has a mean length of 1m and a cross sectional area of .001m^2.A sawcut of 5mm width is made in the ring . calculate the magnetizing current req

Digital electronics, Design a 4-bit synchronous counter that has the follow...

Design a 4-bit synchronous counter that has the following sequence: 0 ?4? 9?12 ? 14 ?15 and repeat using: i) JK FF ii)D FF

Why monitoring and control done, Why Monitoring and control done? Mo...

Why Monitoring and control done? Monitoring and control using microprocessors/computers is often done for the below reasons: - It is safer (faster response to non-standar

Need of microphone in telephone hand set, Q. Need of Microphone in telephon...

Q. Need of Microphone in telephone hand set? Microphone: For all practical purposes, microphone is transmitter for telephone. The microphone converts acoustical signals in the

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd