Find the diameter of drawn tubing , Mechanical Engineering

Assignment Help:

Find the diameter of drawn tubing (e = 0.0015 mm) to transport 0.002 m3/s of 20oC water over 400 m length so that the head loss does not exceed 30m by using

(i)  Moody diagram

(ii) Swamee and Jain formula

 


Related Discussions:- Find the diameter of drawn tubing

Thermodynemics, explain the following terms in brief:- point function and p...

explain the following terms in brief:- point function and path funtion

Necessity of cooling system , Necessity of Cooling System To preve...

Necessity of Cooling System To prevent the engine from excessive heating. To avoid the piston seizure due to thermal expansion. To prevent burning of lubricant a

Surface hardening, SURFACE HARDENING: In many conditions surface harde...

SURFACE HARDENING: In many conditions surface hardening instead of throughout hardening only is enough to serve the reasons. Gears are illustrations. Surface hardening is atta

Evaluate the absolute velocity of jet, A jet of water moving at 8 m/sec. im...

A jet of water moving at 8 m/sec. impinges on a concave-shaped vane to deflect the jet through 120 o when stationary. If the vane is moving at 5 m/sec., calculate the angle of jet

Deadlock states, Deadlock States Deadlock is a detrimental phenomenon i...

Deadlock States Deadlock is a detrimental phenomenon in the shop floor; here part flow is inhibited because of unsuitable scheduling decisions made via the computer controller.

Show gasket compression, Q. Show Gasket Compression? Gasket compression...

Q. Show Gasket Compression? Gasket compression can also be used as a guide for limiting bolt torque. Spiral wound gaskets should be compressed to an average of 75% of origin

Capp for machining process, CAPP for Machining Process This explained ...

CAPP for Machining Process This explained mainly two different approaches to Computer Aided Process Planning, i.e.  (a) Variant approach, and  (b) Generative approach.

Inspection of flange assembly, Q. Inspection of Flange assembly? Flange...

Q. Inspection of Flange assembly? Flanges shall be clean and free of old gasket fragments, scratches, burrs, pits, etc. if needed, the flange surfaces shall be cleaned with a s

Two possible materials for casing, Two Possible Materials for Casing T...

Two Possible Materials for Casing Two possible materials for the casing would be a. Polypropylene or b. An aluminium 1/3 per cent silicon-casting alloy (LM6). Conclu

Evaluate the least pull, Evaluate the least pull, through the center of whe...

Evaluate the least pull, through the center of wheel: A uniform wheel having 600 mm diameter, weighing 5KN rests against rigid rectangular block of 150mm height as shown in t

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd