Find minimum thickness, Mechanical Engineering

Assignment Help:

A 1.2 m diameter steel pipe carries oil of relative density 0.822 under a head of 70 m of oil. What minimum thickness of 120 MPa (yield stress) steel would be required for a safety factor of 1.5?


Related Discussions:- Find minimum thickness

Define the effect of feed, Define the Effect of Feed Increase in feed r...

Define the Effect of Feed Increase in feed rate deteriorates surface finish. It is observed that a rate of feed in the range from0.12 to 0.15 mm per revolution has a negligible

Horizontal hinge, 2 x 2 m square gate opens clockwise on a horizontal hinge...

2 x 2 m square gate opens clockwise on a horizontal hinge located at point A, which is 100 mm below the centroid of the gate. The gate sits against solid rubber blocks which create

determine the minimum cross section area of graph, To design a cantilevere...

To design a cantilevered truss to support the loads shown in the figures, two layouts are proposed as shown in Figs. A and B. All truss members are steel with allowable stress of 2

Compressors, How can I construct a tyre pumping machine.

How can I construct a tyre pumping machine.

Find the coefficient of friction between ladder and floor, Find the coeffic...

Find the coefficient of friction between ladder and floor: A ladder of 5m long rests on horizontal ground and leans against smooth vertical wall at an angle of 70° with the h

Nature of bending stress, According to the explanation, why reverse will ha...

According to the explanation, why reverse will happen in the case of cantilevers? ( that is, tensile stresses will be induced in upper layers and compressive stresses will be induc

Desing, what is the maximum principle stress

what is the maximum principle stress

Classification based on mode of welding, Classification Based on Mode of We...

Classification Based on Mode of Welding Manual welding: In this welding the entire welding operation is performed and controlled by hand. Here, there are two movements involv

Explain working of nozzles, Q. Explain working of Nozzles? Nozzles supp...

Q. Explain working of Nozzles? Nozzles supporting agitators, pumps, or other mechanical equipment, shall be suitably reinforced to withstand the mechanical loadings, specified

Harmonic motion equilibrium, (a) Split up the harmonic x = 8 sin(ωt + 45°),...

(a) Split up the harmonic x = 8 sin(ωt + 45°), into two harmonic motions, one of which has amplitude of 10 and phase difference zero. (a) A body is subjected to two harmonic mot

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd