final year project, Mechanical Engineering

Assignment Help:
Project is about Heat exchanger kit named TE 93.....Project guide has told us to do something with it..without modifying the project largely.....i came up with change of material of thermocouple (shown by temp t1 in the link) from copper to aluminium and comparing the results......here is the link.......https://www.gunt.de/static/s3593_1.php?p1=0&p2=&pN=search;Volltext;wl%20314

Related Discussions:- final year project

Setting and installations of insulation, Q. Setting and installations of in...

Q. Setting and installations of insulation? The setting and installations of insulation shall be to Specification No. later. The steam drum surfaces shall be insulated with

Determine tension in horizontal rope , Determine tension in horizontal rope...

Determine tension in horizontal rope: Q:  A 500N cylinder, 1 m in diameter is loaded between cross pieces AE and BD that make an angle of 60º with each other and are pinn

Show material selection process, Q. Show Material selection process? • ...

Q. Show Material selection process? • Design life shall be based on project design criteria and normally 10 to 15 years' service life specified for well pads, 20-25 years for C

Write the functional element of instrument system, a) Mention typical appli...

a) Mention typical application of instrument system with illustratation. b) Write down about the functional element of instrument system with examples. c) Define the key term

Explain about hydrostatic test, Q. Explain about Hydrostatic Test? All ...

Q. Explain about Hydrostatic Test? All paragraph must be met when the hydrostatic test is employed. UG-99(b), including footnote 32, shall be considered to be the standard hyd

Find out bulk modulus, Find out bulk modulus: A steel bar of 25 mm dia...

Find out bulk modulus: A steel bar of 25 mm diameter was tested on a gauge length of 250 cm in tension and in torsion. A tensile load of 50 kN generated an extension of 0.13 m

Green chemistry, what is green chemistry with diagram

what is green chemistry with diagram

Find out tension in the rop, Find out tension in the rop: Two blocks A...

Find out tension in the rop: Two blocks A and B are associated as shown in Figure (a). Mass of block A is 15 kg and this is resting on a surface having a coefficient of fricti

Properties of system - thermodynamics, Define different types of properties...

Define different types of properties: Sol: For defining any system certain parameters are needed. Properties are the observable characteristics of system, which can be emplo

Where pneumatic system is used, Any system needs redundancy in work needs p...

Any system needs redundancy in work needs pneumatics, because the compressor of the pneumatic system has periodical operations (intermittent work, not as hydraulic pump). The compr

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd