Explain the transfer characteristics, Electrical Engineering

Assignment Help:

Q. Explain the transfer characteristics in a few words ?

The transfer characteristics are a plot of an output (or a drain) current versus an input controlling quantity. There is therefore a direct transfer from input to output variables. If the relationship were linear, the plot of ID versus VGS would result in a straight line between IDSS and VP. However a parabolic curve will result because a vertical spacing between steps of VGS on the drain characteristics decreases as VGS becomes more and more negative.


Related Discussions:- Explain the transfer characteristics

What insulators have in large size, Insulators have (A) A full valence...

Insulators have (A) A full valence band. (B) An empty conduction band. (C) A large energy gap. (D)All the above. Ans: Insulators have a large energy gap.

Explain the importance of planning in an organisation, Question 1: Plan...

Question 1: Planning is one of the primary functions of management. (a) Explain the importance of planning in an organisation. (b) How can managers develop an effective a

Input voltage to system and the output motor speed, A system contains an am...

A system contains an amplifier with a gain of 10 offering the armature voltage for a motor which provides an output speed which is proportional to the armature voltage, the constan

Trends, what is south africas perspective?

what is south africas perspective?

Calculate the rms value, The sinusoidal voltage source in the circuit shown...

The sinusoidal voltage source in the circuit shown in Fig. is developing an rms voltage of 2000 V. The 4 ? load in the circuit is absorbing four times as much average power as the

Define the baud rate with respect to serial communication, With respect to ...

With respect to serial communication define the baud rate. The rate of data transfer into serial data communication is denoted in bps. Bits per second (bps) are the rate of in

Explain the signals hold and sid, Explain the signals HOLD, READY and SID ...

Explain the signals HOLD, READY and SID HOLD indicates that a peripheral such as DMA controller is requesting the use of address bus, data bus and control bus. READY is used to

Addition of binary numbers , Addition of binary numbers Example:   Ad...

Addition of binary numbers Example:   Add  110010102 ( -510). and 00000101 2 (+5 10 ) Solution :                         Binary                                   signed

What is cascade, An arrangement of Windows so every window is neatly stacke...

An arrangement of Windows so every window is neatly stacked with only the title bar of every window is showing.

Control system., how does Proportional band affect the performance of contr...

how does Proportional band affect the performance of control system?

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd