Explain the term simplex transmission, Electrical Engineering

Assignment Help:

Explain the term simplex transmission.

Data in a simplex channel is always one method. Simplex channels are not frequently used because this is not possible to send back error or control signals to the transmit ending. An illustration of a simplex channel in a computer system is the interface among the keyboard and the computer, in that key codes require only be sent one way from the keyboard to the computer system.


Related Discussions:- Explain the term simplex transmission

amplitude modulated waveform, The method by which electrical signals conve...

The method by which electrical signals convey information has been described. Systems components have been selected and interfaced to enable a chosen system to perform a desired o

Higher order address bus - pins and signals , Higher order  Address Bus ...

Higher order  Address Bus The 8085 microprocessor  has 8 pins  dedicated to higher order address A15 - A8. These pins  are used to connect  higher  order address bus. These  p

What is centralized spc, Q. What is centralized SPC? In centralized con...

Q. What is centralized SPC? In centralized control, all control equipment is replaced by a single processor which should be quite powerful. It should be capable of processing 1

Semiconductors, Charge density In a semiconductor

Charge density In a semiconductor

Write short note on a negative clamper, Q. Write short note on a negative c...

Q. Write short note on a negative clamper ?   A circuit which places the negative peak of a signal at a desired level is known as a negative clamper (1). During the

Use of cro for frequency measurement, Q. Explain the use of CRO for frequen...

Q. Explain the use of CRO for frequency measurement.   Measurement of frequency: The frequency of the periodic signals is easily measured with a CRO. The frequency of a si

Governer, governer characteristics

governer characteristics

Calculation of aggregate technical and commercial loss, Calculation of Aggr...

Calculation of Aggregate Technical and Commercial Loss The concept of AT&C loss was introduced within 2001-02. The AT&C losses are presently in the range of 18% to 62% in seve

Sketch the asymptotic bode diagrams, Q. Sketch the asymptotic Bode diagrams...

Q. Sketch the asymptotic Bode diagrams for the following functions:

Matlab, how to model a doubly fed induction generator inside simulink?

how to model a doubly fed induction generator inside simulink?

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd