Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Explain properties and application of Copper.
Properties
1) Cooper is reddish brown in color.
2) Cooper is malleable and ductile and can be forged, cast, rolled, machined and drawn.
3) Cooper melts at 10830C.
4) Cooper easily alloys with other metals.
5) Electrical resistivity of copper is 1.7x10-8 ?-m.
6) Tensile strength for copper is 210 MN/m2.
7) Cooper is highly resistant to corrosion.
8) Cooper is a non-magnetic material.
Applications:
It is used in conductor wires, coil windings of transformers and generators, cables and bus bars.
For a vehicle suspension, a basic two-degree-of-freedom "quarter-car" model would be slightly more complicated than the spring-mass-damper system I chose to study in Figure 1. The
You have been given a DC motor to characterize. What three measurements are required in order to develop the torque-speed curve and the acceleration curve for the unloaded motor?
A three-phase, 400-V, wye-connected induction motor takes the full-load current at 45 V with the rotor blocked. The full-load slip is 4%. Calculate the tappings k on a three-phase
Q. Write a short note on the frequency response of a R-C coupled amplifier. At low frequencies ( , the reactance of coupling capacitor Cc is quite high and hence very small pa
Q. What is the function of CT and P.T and where they are used? Ans: The full form of CT is Current transformer and is used for calculating of current. The full form of PT is
Write shorte note on Carbon. Carbon: The rate of commutator wear in electrical machines is greatly decreased by using brushes made of carbon. Carbon (C) is also used in autom
Copy data byte 10H LDAX instruction Example : Copy data byte 10H stored at memory location 3020 H to the accumulator using LDAX instructions. Solution : To use
equivalent circuit for transistor using h parameters
Connect the two signals used in section 2 above to the "Multiplier" module. Make sure that you record the amplitude of each signal. Observe and record the resultant waveform in
Regions of operation: Applied voltages Mode E Forward active E C Saturation E > B
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +91-977-207-8620
Phone: +91-977-207-8620
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd