Explain polling, Electrical Engineering

Assignment Help:

What is meant by polling?

In polling schemes, a set of address lines is driven by the controller to address every of the masters in sequence. When a bus request is received from a device by the controller, it produces the address on the address lines. .If the generated address matches with that of the requesting masters, the controller activates the BUSY line.

Once the busy line is activat3Write some benefits of loosely coupled systems controller stops generating further address. 

 


Related Discussions:- Explain polling

1-phase full bridge inverter will rl load , 1- Phase Full  Bridge  inver...

1- Phase Full  Bridge  inverter will RL Load For a  resistive load R the load  current  wave form  will be  identical with load  voltage wave form  and feedback  diodes will

Design of matching networks for amplifiers, Design a low noise amplifier us...

Design a low noise amplifier using an Infineon RF transistor BFP640. The amplifier is to be used to amplify the L2 GPS signal and so the centre frequency is 1227MHz and bandwidth 4

Various steps in designing the counter, Design a mod-15 counter. Explain th...

Design a mod-15 counter. Explain the various steps in designing the counter

Selection of right- flex in electricity and gas hazards, Selection of Right...

Selection of Right- Flex : It is also important that the flex we choose is appropriate to the appliance used. Like fuses, the cables and flexes are also rated according to their

What is the impulse response of this filter, Consider the filter h[n,m] des...

Consider the filter h[n,m] describing the input-output relationship below: g[n,m]=f[n-1,m]+ f[n,m-1]+ f[n+1,m]+ f[n,m+1] a)  What is the impulse response of this filter? b

What is the need of modem in data communication, Q. What is the need of MOD...

Q. What is the need of MODEM in data communication? Need of Modem: Modems are used to interface computers, computer networks in addition to other terminal equipment to teleco

Principle of oscillation in an rc phase shift oscillator, Q. What is the ba...

Q. What is the basic principle of oscillation in an RC phase shift oscillator. With a neat sketch explain its working? For producing oscillations there must have positive feedb

Find the meter reading assuming that the averaging is done, Q A residence i...

Q A residence is supplied with a voltage v(t) = 110√2cos120πt Vand a current i(t) = 10√2cos120πt A. If an electricmeter is used tomeasure the average power, find the meter reading,

Describe the process design and application, Disinfection of water streams ...

Disinfection of water streams originating from potable water plants is key in protecting environmental health. Describe the process design and application, along with potential pro

Determine the initial value and final value of the current, Given the frequ...

Given the frequency-domain response of an RL circuit to be determine the initial value and the final value of the current by using the initial-value and final-value theorem

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd