Explain pole core and pole shoe - dc generator, Mechanical Engineering

Assignment Help:

Pole core and pole shoe

The pole cores are made of steel laminations that are insulated from each other and riveted together. Every pole core has a pole shoe having a curved surface. The functions of pole shoe are

(i)  To support the ?eld coil and

(ii)  To enhance the cross sectional area of the magnetic circuit and

(iii)  To decrease its reluctance.

 


Related Discussions:- Explain pole core and pole shoe - dc generator

Find out the velocity of the mass, Find out the velocity of the mass: A...

Find out the velocity of the mass: A mass of weight 29.4 Newton is subjected into a time dependent force, F(t)  = (3t 3  + 5) along x direction. Find out the velocity of the

Bending stresses, Determine: Reaction forces at the supports The shear an...

Determine: Reaction forces at the supports The shear and moment diagrams The location and value of the maximum shear and moment The cross section is an angle section as given in

Explain about napthenic acid corrosion, Q. Explain about Napthenic Acid Cor...

Q. Explain about Napthenic Acid Corrosion? Some crude oils contain napthenic acids, which, at elevated temperatures, may contribute to more active corrosion with or without the

Where pneumatic system is used, Any system needs redundancy in work needs p...

Any system needs redundancy in work needs pneumatics, because the compressor of the pneumatic system has periodical operations (intermittent work, not as hydraulic pump). The compr

Assignment, A cantilever beam is loaded with a concentrated. Force of 5kN a...

A cantilever beam is loaded with a concentrated. Force of 5kN at the free end. The length of the cantilever beam is 1m having cross section of 50×50mm. determine the equation for b

What is a cotter joint, These parts of joints are used to connect two rods,...

These parts of joints are used to connect two rods, which are under compressive or tensile stress. The ends of the rods are in the manner of a socket and shaft that fit together an

Various components of transmission system , Various Components of Transmiss...

Various Components of Transmission System Primary Drive Gear : It is mounted on crankshaft. It transfers power to primary driven gear. Primary Driven Gear : It is

Explain the Vacuum or vacuum pressure, Vacuum Or Vacuum pressure (P vacc ) ...

Vacuum Or Vacuum pressure (P vacc ) It is the pressure of a fluid that is always less as compared to the atmospheric pressure. Pressure (that is vacuum) in a steam condenser is

Cutting technology., can you explain about merchant circle,cutting forces

can you explain about merchant circle,cutting forces

What will be the alteration of pressure, A copper tube 1.2 m long, has 80mm...

A copper tube 1.2 m long, has 80mm internal diameter and 2 mm wall thickness. It has closed ends, and is filled with water under pressure. What will be the alteration of pressure i

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd