Explain p trap, Civil Engineering

Assignment Help:

Q. Explain P Trap?

Trap is a depressed or bent sanitary fittings which always remains full of water it is water seal.

Its functions are to prevent passage of foul air or gases but at the same time allows flow of sewage through it.

Effectiveness of trap depends on depth of water seal ( Varies from 25 to 50 mm )

Requirement of a good trap as under -

i. It should be capable of being easily cleaned.

ii. It should be easily fixed with drain.

iii. Simple.

iv. Passes adequate water seal.

v. Surface should have smooth finish.

According to shape the traps are of the following three type -

1. P Trap. 2. Q Trap. 3. S Trap.


Related Discussions:- Explain p trap

Curves, procedure on conducting curves in field

procedure on conducting curves in field

Conditions of pumping performance, Question In conditions of pumping pe...

Question In conditions of pumping performance, how have to engineers determined use of radial flow pumps and axial flow pumps ? Answer Exact speed is usually define

Calculate the specific gravity of the soil particles, A piece of clay taken...

A piece of clay taken from a sampling tube has a wet weight of 1.553 N and volume of 95.3 cm 3 . After drying in an oven for 24 hours at 105°C, its weight 1.087 N. Suppose the spec

Diver qualification - diving operation for bridge inspection, Define Diver ...

Define Diver Qualification - Diving Operation for Bridge Inspection? The requisite qualification for divers and diving supervisors are given in IS 10291 -1982, which stipulates

Analysis of prestress and bending stresses, Normal 0 false fa...

Normal 0 false false false EN-IN X-NONE X-NONE

Major compensation of using hdpe as compared with cast iron, Question N...

Question Now, mainly flap valves are ended of HDPE. What is the major compensation of using HDPE as compared with cast iron? Answer (i) It has no response with sewage a

Third law of thermodynamics, Is there any application by using the third la...

Is there any application by using the third law of thermodynamics. A Actual application without explained the calculation

Movement accommodation factor for joint sealant, Movement accommodation fac...

Movement accommodation factor is normally specified by manufacturers of joint sealants for designers to design dimension of joints. It is stated as the total movement that a joint

Differentiate, differentiate between components and resolved parts

differentiate between components and resolved parts

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd