Explain instruction sets of 8085, Electrical Engineering

Assignment Help:

Explain instruction sets of 8085.

a)  Data transfer group - MOV, MVI, LXI.

b)  Arithmetic group - ADD, SUB, INR.

c)  Branch group - JMP, JNZ, CALL.

d)  Logical group -ANA, XRA, CMP.

e)  Stack I/O and Machine control group - PUSH, POP, IN, HLT.

 


Related Discussions:- Explain instruction sets of 8085

Explain the steps of the evolution of the microcontroller, Question: a)...

Question: a) Give one reason why a "subroutine" could be written into the body of the main program. b) With the help of the diagram below, write down the sequence of the ni

Distributed Control Sytems, 1. Produce a fully-labelled sketch to show the ...

1. Produce a fully-labelled sketch to show the components of a Direct Digital Control system. 2. State the minimum number of printed-circuit cards required to construct a basic co

Illustrate in detail b-spline and cubic bezier surfaces, Define ruled surfa...

Define ruled surface and surface of revolution. Illustrate in detail B-spline and cubic Bezier surfaces with their important properties.

Use delta-wye transformation for network reduction, Use delta-wye transform...

Use delta-wye transformation for network reduction and determine the current through the 12- resistor in the circuit of Figure(a).

Compute the source current, Q. A 230-V, single-phase, 60-Hz source supplies...

Q. A 230-V, single-phase, 60-Hz source supplies two loads in parallel. One draws 10 kVA at a lagging power factor of 0.80 and the other draws 6 kWat a lagging power factor of 0.90.

Logic Gates, A former employs a servant to look after his form house. He in...

A former employs a servant to look after his form house. He instructs the servant to keep a watch on his goat. So that he does not harm the kitchen garden, when the entrance-door

ET1410, MODULE 2 EXERCISE: OP-AMP CONFIGURATION

MODULE 2 EXERCISE: OP-AMP CONFIGURATION

Describe two ways of correcting the blur, Q. We have discussed three differ...

Q. We have discussed three different color spaces: RGB, HSI and CMY(K). Specify the need for multiple color spaces. Why can we not use only one? Q. A telescope in an observatory

Impedance / DUTT, 3) The impedance for a 120 km, 230-kV line is given as j ...

3) The impedance for a 120 km, 230-kV line is given as j 0.9 ohm/km and j 0.6 ohm/km for self and mutual terms respectively; resistance is neglected. The mho characteristic for the

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd