Explain index mode and base address mode, Electrical Engineering

Assignment Help:

Explain index mode and base address mode (with examples) available in microprocessors.

Index Mode and Base Address Mode:

Address supplied through the instruction is added to an index register's contents.
Base address mode is same except, the index register is replaced through a base address register.

Illustration:

LDAC 5(X); here X = 10

Reads data by location (5 + 10) = 15 and stores this in the accumulator.

Related Discussions:- Explain index mode and base address mode

Exponentially weighted moving average, 1. The Excel file contains daily clo...

1. The Excel file contains daily closes for the S&P/TSX composite index from January 2, 2008 to December 31, 2010. Assuming that December 31, 2010 is the current day. A) Using the

Differences between vga and cga graphics adapters, Q.9 What are the main...

Q.9 What are the main differences between VGA and CGA graphics adapters? Ans: Colour Graphics Adapter (CGA), initially also known as Colour/Graphics Adapter or IBM Colo

For zero flag - conditional jumps , For Zero Flag JZ ( Jump on Ze...

For Zero Flag JZ ( Jump on Zero) and JNZ ( jump on no zero ) Instruction JZ transfer the execution of the program to the speciffed address if zero flag is set (Z=

Permanent magnets, If a permanent magnet creates the flux in a magnetic cir...

If a permanent magnet creates the flux in a magnetic circuit, the flux exists without the need for a coil, so how does Amperes Law apply to this case? In this case the flux is

Erc and kpi, ERC and KPI The company requires understanding the strate...

ERC and KPI The company requires understanding the strategic and nearing term impact of the Regulator's orders / tariff approval process. Once these dimensions are understood,

Configured the dual processor architecture, Configured dual processor archi...

Configured dual processor architecture In centralized SPC, dual processor architecture can be configured to operate in following one of three modes: 1. Standby mode: In

Transformer, how back emf is produced in transformer?

how back emf is produced in transformer?

Find the resonant angular frequency, Consider the circuit shown in Figure w...

Consider the circuit shown in Figure with R 0 , (b) the quality factor Q, and (c) the maximum impedance Z m . Comment on the applicability of the universal resonance curve.

Illustrate balanced delta-connected load, Next, let us consider the case of...

Next, let us consider the case of a balanced delta-connected load with impedance of 5 45° supplied by a three-phase, three-wire 100-V system, as shown in Figure (a). We shall dete

Minimum value of rl that can be used, Verify the minimum & maximum load cur...

Verify the minimum & maximum load current for which the zener diode will keep regulation. Find the minimum value of RL that can be used. The zener diode has V Z = 12V, I ZK =

Write Your Message!

Name

Email id

Message

Verfication Code

User Account

All Pages