Evaluate the rankine efficiency, Mechanical Engineering

Assignment Help:

In a Rankine cycle, the steam at inlet to turbine is saturated at a pressure of 35 bar and the exhaust pressure is 0.2 bar. Evaluate:

(i) The pump work,

(ii) The turbine work,

(iii) The Rankine efficiency,

(iv) The condenser heat flow,

(v) The dryness at the end of expansion. Assume flow rate of 9.5 kg/s.


Related Discussions:- Evaluate the rankine efficiency

Explain about unit pipe racks, Q. Explain about Unit pipe racks? Unit p...

Q. Explain about Unit pipe racks? Unit pipe racks are the main arteries carrying the pipes and cables into the units, and as such should be centrally located. They are usually

Design a shaft to transmit power, Design a shaft to transmit power from a m...

Design a shaft to transmit power from a motor to a lathe head stock through a pulley by means of a belt drive. The pulley weighs 200 N and is located at 300 mm from the centre of t

Benefits of a good layout and design of plant, Q. Benefits of a good layout...

Q. Benefits of a good layout and design? The benefits of a good layout and design cannot be overemphasized. They provide an irreplaceable safety factor throughout the life of t

Clutch spring height-clutch slipping, Clutch spring height: Check clutch s...

Clutch spring height: Check clutch spring height with a Vernier caliper. Spring height should be of minimum height of 25.55 mm.

Meaning, What different of blow hole and pin hole

What different of blow hole and pin hole

Benefits of registration in entrepreneurship development, Benefits of Regis...

Benefits of Registration: Units would normally get registered to avail some benefits, incentives or support given either by the Central or State Govt. The regime of incentives off

Instantaneous stress and elongation - bar, Instantaneous stress and elongat...

Instantaneous stress and elongation: What shall be the instantaneous stress & elongation of a 25 mm diameter bar, 2.6 m long, suspended vertically, if any mass of 10 kg falls

General reasons for defects, GENERAL REASONS FOR DEFECTS The imp...

GENERAL REASONS FOR DEFECTS The importance of weld quality is increasingly felt as we go ahead with the fabrication of sophisticated products using higher strength mater

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd