Estimate the size estimating the rcc structures, Civil Engineering

Assignment Help:

PART - A

1.  Can you enumerate the benefits of individual wall method of estimation?

2.  Estimate the single room of size  3m x 4m x height 3m  using individual wall method?

3.  Which method you will choose - center line method or individual wall method for estimation of buildings?

PART - B

4.  Write the parameters you should keep in mind while estimating the RCC structures?

5.  A singly reinforced concrete beam is 200 mm wide and 400mm deep to the center of the tension reinforcement which consists of 4 bars of 16mm diameter. If the stresses in concrete and steel are not to exceed 5N/mm2 and 140 N/mm2, Estimate the various materials for the said beam?.

6. A single room has four columns of size 400mm x 600mm x 3m. Estimate the total concrete required? Also estimate the various constituents of concrete? Use M20 grade of concrete? Assume the suitable data.

 


Related Discussions:- Estimate the size estimating the rcc structures

Determine the stresses set up in the brass, Determine the stresses set up i...

Determine the stresses set up in the brass: A compound bar is constructed from three bars 50 mm wide by 12 mm thick fastened together to form a bar 50 mm wide by 36 mm thick.

Determine the coordinate for point r, For the project work points (x,y) sho...

For the project work points (x,y) shown in the figure the bearing of point R is due West. The coordinate for point R is most nearly:    Solution: Determine the length o

Explain the traffic safety - transportation, Explain the Traffic Safety - T...

Explain the Traffic Safety - Transportation Crash rates are normally considered better indicators of risk than crash frequencies.  a. Crash rates for intersections are norma

What do you mean by distressing, Q. What do you mean by Distressing? Di...

Q. What do you mean by Distressing? Distressing is the operation under taken with or with out rail tensors to secure stress free condition in the LWR at a desired rail temperat

Maximum shear stress, Maximum shear stress: The state of stress at a c...

Maximum shear stress: The state of stress at a critical point of a strained solid is given by σ x = 70 kN/mm 2 , σ y = - 50 kN/mm 2 and τ xy = 45 kN/mm 2 . If the strength

Types of limes and their properties, Types of Limes and their Properties ...

Types of Limes and their Properties The limes are classified in three categories as fat lime, hydraulic lime and poor lime: (1) Fat lime: It is composed of 95 percentage o

Concrete, if the slump of concrete drops how to rectify it

if the slump of concrete drops how to rectify it

Purpose of tar in bituminous materials, Q. Purpose of tar in bituminous mat...

Q. Purpose of tar in bituminous materials? Tar is usually incorporated in bituminous materials due to the below reasons: (i)  Blending of tar with bitumen possesses better b

Strenght of meterials 2, Difference between direct and bending stress diagr...

Difference between direct and bending stress diagrams

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd