Energy emissions per usage, Other Engineering

Assignment Help:

Q. The Energy related CO2 emissions per usage are in Florida:

1992_Energy emissions per usage.png


What is the CO2 emission in kg/kWh and in lb/kWh in Florida?

Knowing the emissions and the total generation, we can easily find the emission in kg/kWh: 0.49 kg CO2/kWh. A pound is equivalent to 0.454 kg, therefore the conversion in lb/kWh provides: 1.07 lb/kWh.


Related Discussions:- Energy emissions per usage

Engine vibration indication, Engine Vibration Indication The engine vib...

Engine Vibration Indication The engine vibration monitoring (EVM) system shows the out of balance force for the N1 and N2 shaft. High engine vibration shows engine damage or

Riveting, Riveting  is a fixed fastening procedure in which the end of the ...

Riveting  is a fixed fastening procedure in which the end of the metal pin is pressed over or spread out by hammering operation. Wrought iron and steel are used for the riveting an

Leverage, defination of leverage,objectives,enterpritation,analysis,conclus...

defination of leverage,objectives,enterpritation,analysis,conclusion,references,review of literature.

Weighted average cost of capital, Using this link and the information there...

Using this link and the information therein ( http://www.sec.gov/Archives/edgar/data/1110452/000119312507151600/d20f.htm#tx19738_13.) find Air France’s weighted average cost of ca

Thermofluids 1- aeronautical option, general energy equation, non- flow ene...

general energy equation, non- flow energy equation, steady flow equation, joule''s law

Mining, Students are to undertake a tunnel blast design for the following c...

Students are to undertake a tunnel blast design for the following conditions: • Tunnel is 5.5m wide by 5.5.m high • Rock is a granite with a UCS of 300 MPa • Drill hole diameter is

Engineering science , the axle diameters of differential wheel and axle lif...

the axle diameters of differential wheel and axle lifting machine are 254mm and 129mm respectively.the load has a mass of 36kg and the effort required is 300N.if the efficiency is

GSM BASED MOTOR ON AND OFF, in this project i want to start my motor by giv...

in this project i want to start my motor by giving a miscall so how can i decode that miscall in micro controller?

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd