Electrodes- cast iron electrodes, Mechanical Engineering

Assignment Help:

Cast Iron Electrodes

There are three types of electrodes for welding of cast ions.

a) Monel-cored electrodes (30 % Ni 70 % Cu)
b) Fe-Ni (40 % Ni)
c) Ni-electrodes (97 E)

These electrodes can be used for welding of machinable welds whereas for non machinable parts of cast iron, any low hydrogen electrode can be used with slight preheating of the job.


Related Discussions:- Electrodes- cast iron electrodes

What will happen if air filter is not used?, (a) What will happen if air fi...

(a) What will happen if air filter is not used? (b) What are the components of an air filter? (c) What precautions should be followed while cleaning the air filter? (d) What grade

Calculate the maximum stresses in the end plate, The end plate of a tube is...

The end plate of a tube is made from 4mm thick steel plate as seen in the figure below. If a 30mm diameter rod welded to the plate is subjected to a force of 10kN, what would be th

Pressure vessel materials, Pressure Vessel materials shall be as specified ...

Pressure Vessel materials shall be as specified on the Vessel Data Sheet. All attachments to vessels shall be of the same ‘P Number' material as that for the pressure envelope,

Parts of wilson hartnell governor, what are the parts of wilson hartnell go...

what are the parts of wilson hartnell governor with their designation?

Determine steady state error, Derive mathematical equation for the time res...

Derive mathematical equation for the time response of a first order system subjected to ramp input. Draw the response curve and determine steady state error. Give some examples of

External coatings on vessels, Q. External coatings on vessels? All pres...

Q. External coatings on vessels? All pressure vessels that will be installed underground shall have an external coating applied according to the following procedure: • All e

Illustrate theories in planning a machining sequence, Illustrate theories i...

Illustrate theories in planning a machining sequence A component requires several machining operations to bring it to a final shape. The sequence of these operations are arran

Illustrate the general shear failure in bearing capacity, Illustrate the ge...

Illustrate the general shear failure in bearing capacity. General Shear Failure: In this case of failure, contiguous failure surfaces develop between the edges of the footin

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd