Dynamic force transfer test of shock transmission unit, Civil Engineering

Assignment Help:

Define Dynamic Force Transfer Test of Shock Transmission Unit?

This test mainly prove the lock up capability of the device. The STU shall be loaded in tension from zero to the full design load in less than 0.50 seconds and the force sustained for 5 seconds. Then the load shall be reversed to the full design load in less than 0.50 seconds and held again for 5 seconds. The acceptance criteria for the above test shall be that the deflection during the loading of the positive force and the negative force shall be no greater than 6 mm and the deflection during sustained load portion shall not exceed 3 mm.


Related Discussions:- Dynamic force transfer test of shock transmission unit

Describe the consolidation settlement, Q. Describe the Consolidation Settle...

Q. Describe the Consolidation Settlement? The resulting settlements which are time-dependent and are termed consolidation settlements. After the consolidation settlements take

Surveying, A pre- engineering base line was run down a very steep hill.rath...

A pre- engineering base line was run down a very steep hill.rather than measure horizontaily down hill with steel tape: surveyor measured the vertical angle with the theodolite and

CANTILEVER RETAINING WALL, NEED TO DESIGN A CANTILEVER RETAINING WALL 8M HI...

NEED TO DESIGN A CANTILEVER RETAINING WALL 8M HIGH, SATURATED UNIT WEIGHT IS 16KN/M3, SURCHARGE IS 7KN/M2, LOAD ABOVE WALL SUPPORTED ON WALL STEM IS 10KN/M RUN, ANGLE IN INTERNAL F

Civil Engineering Technology, Why hoisting and conveying equipment is very ...

Why hoisting and conveying equipment is very important in civil engineering?

I have a take home quiz, Hello I have a take home final needs be ordered, d...

Hello I have a take home final needs be ordered, do you have very well skilled professionals to make it?

Effect of footing size on stress zone, Q. Effect of Footing Size on Stress ...

Q. Effect of Footing Size on Stress Zone? The modulus of elasticity of the soil may be determined by plotting stress-strain diagram based on triaxial test or plate load test.

Construction measurment, calculating quantity of excavation, formwork, conc...

calculating quantity of excavation, formwork, concrete

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd