Dissimilarities in function b/w rock anchors and rock socket, Civil Engineering

Assignment Help:

Question

What are main dissimilarities in function between rock anchors and rock sockets?


Answer

Rock anchors are used first and foremost for resisting uplift forces. On contrary, rock sockets serve three major reasons-

(i) Rock socket friction and end bearing to oppose vertical load;

(ii) Inert conflict of rock sockets contribute to resistance of lateral load; and

(iii) Socket shaft resistance is also used for resist uplifting forces. But only 70 percent of this ability has to be used because of effect of unenthusiastic Poisson ratio.

 


Related Discussions:- Dissimilarities in function b/w rock anchors and rock socket

Show the benefits of adopting marine fill, In reclamation involving large v...

In reclamation involving large volumes of fill and tight programme, shall engineers use marine fill or mud extracted from land borrow area as filling material?  There are two

Transportation, investigation of strength properties of black cotton soil s...

investigation of strength properties of black cotton soil stabilised with fly ash and georeinforcement

Determine the meaning of relaxation of steel, Determine the meaning of Rela...

Determine the meaning of Relaxation of Steel If the strain in steel is kept constant, it is seen that stresses in it reduce with time. It is called as relaxation of steel. Ten

Explain the strength design (lrfd), Explain the Strength Design (LRFD)   ...

Explain the Strength Design (LRFD)   1. γ Factors are applied to loads and φ factors applied to resistance. 2. Unfactored service loads receive a load factor γ > 1.0

Rectilinear motion, A train starts from rest as A and accelerates at 1,7m/...

A train starts from rest as A and accelerates at 1,7m/s2 to full speed at which it maintains until the brakes gives it a deceleration of 1,7m/s2 to stop at B. AB=1,6km. determine

Check rail on curve, Check Rail on Curve - Check Rails are basically p...

Check Rail on Curve - Check Rails are basically provided on sharp curves to reduce the lateral wear on the outer rail. They also prevent the outer wheel flange from mounting o

Measure the safe load on the pile, A wood pile of 10 m length is driven by ...

A wood pile of 10 m length is driven by a 1500 kg drop hammer falling by 3 m to a final set equal to 1.25 cm per blow. Measure the safe load on the pile using the Engineering Ne

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd