Discuss the term d/a conversion, Electrical Engineering

Assignment Help:

Discuss the term D/A conversion.

D/A conversion: Digital-to-analog or analog-to-digital conversions are two very significant aspects of digital data processing.  Digital-to-analog includes conversion of digital data in equivalent analog data. For illustration, the output of a digital system may be converted to analog by using a D/A converter for driving a servomotor that drives the cursor arm of a plotter or a pen recorder. This clearly demonstrates in this instance DAC emulating decoding device action.


Related Discussions:- Discuss the term d/a conversion

Configured the dual processor architecture, Configured dual processor archi...

Configured dual processor architecture  In centralized SPC, dual processor architecture can be configured to operate in following one of three modes: 1.  Standby mode: In

Calculate power delivered to the network, Calculate power delivered to the ...

Calculate power delivered to the network: 1. A wave is traveling from left to right, emerging from Z g =50 with a peak amplitude of V p =5V. The 1-port network [S] has in=0.5-

Chemistry, Write short note on hardness of water and its units

Write short note on hardness of water and its units

Simulate the circuit using digital simulation techniques, You are the new c...

You are the new chief PCB designer for a small company who are about to become heavily involved in the design and realisation of digital timing products. Your management wants to p

Complex programmable logic device, The small electronics consultancy compan...

The small electronics consultancy company that you work for has been commissioned to design a portable mixed signal heart rate monitor unit for the National Health Service. You hav

Calculate the resistance of the coil of a transistor, A 6 V / 2.5 mA relay ...

A 6 V / 2.5 mA relay is connected in the output stage of a transistor.  The coil is made of aluminium having α = 0.004. The resistance of the coil is 600 ? at 32 o C. Calculate th

Simulation of a standard ic linear regulator, 1.    Introduction The ob...

1.    Introduction The objective of this assignment is to design and evaluate a stabilised discrete linear power supply. The power supply requires to be designed according to t

Define serial in - serial out shift registers, Define Serial In - Serial Ou...

Define Serial In - Serial Out Shift Registers? An essential four-bit shift register can be constructed using four D flip-flops. The register is the first cleared forcing all fo

Find the value of frequency, Although the low side is not as good a choice ...

Although the low side is not as good a choice as the high-side local oscillator frequency, let an AM broadcast receiver be designed with a low-side local oscillator. As fc is varie

Describe what is rim and sim instructions, RIM is Read Interrupt Mask. Used...

RIM is Read Interrupt Mask. Used to ensure whether the interrupt is Masked or not.     SIM is Set Interrupt Mask. Used to mask the hardware interrupts.

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd