Discuss macro assembler directive, Electrical Engineering

Assignment Help:

Discuss MACRO assembler directive with example.

MACRO: A sequence of instructions to that has a name is assigned is termed as macro. Macros and subroutines are the same. These are used for short sequence of instructions while subroutines for longer ones. It executes faster than subroutines.

The MACRO directive informs assembler the starting of a macro. It is used along with ENDM directive to include a macro. The general format of the MACRO directive is as:

 Macro Name that is MACRO ARG1, ARG2, ARG N


Related Discussions:- Discuss macro assembler directive

Phenomenon - fet operation, Phenomenon - Fet operation: For either imp...

Phenomenon - Fet operation: For either improvement- or depletion-mode devices, at drain-to-source voltages very much less than gate-to-source voltages, changing the gate volta

What is resistivity, What is resistivity? Resistivity of a material ma...

What is resistivity? Resistivity of a material may be explained as the resistance of the material having unit length and also unit cross sectional area. Unit of it is ohm-m.

Calculate the time to get the voltage across the capacitor, 1. The circuit...

1. The circuit below will be most efficiently analyzed by obtaining the Thevenin equivalent circuit for the circuit to the left of the points (a-b) on the schematic. The capacitor

Mode1 - power supplies , Mode1 When the positive  pulse  from PWM  is a...

Mode1 When the positive  pulse  from PWM  is applied to the transistor Q shown  in figure  it gets  turned  on. In  this condition current  flows  through  transistor Q and.

Power analyser, Explain frequency selective wave analyser with bandwidth

Explain frequency selective wave analyser with bandwidth

Show cmos logic families, Both DTL and TTL are based on the saturating BJT ...

Both DTL and TTL are based on the saturating BJT inverter. The transistor acts as a switch that connects or disconnects the collector and emitter. The switch is closed when suffici

Testing for continuity-earthing, Testing for Continuity : You may have obs...

Testing for Continuity : You may have observed sometimes that when all the connections in the appliance as well as the plug are made properly the appliance may still not work. Thi

Discuss the assembler directive of offset, Discuss the assembler directive ...

Discuss the assembler directive of OFFSET with example. OFFSET: This is an operator to find out the offset (displacement) of a variable or process regarding the base

Example numerical of dc generator., Q. An 8 - pole dc generator has 500 arm...

Q. An 8 - pole dc generator has 500 armature conductors and has a useful flux per pole of 0.065 web. What will be the emf generated if it is lap connected and runs at 1000 r.p.m.

Explain sampling and pulse modulation, Q. Explain Sampling and Pulse Modula...

Q. Explain Sampling and Pulse Modulation? In most analog circuits, signals are processed in their entirety. However, in many modern electric systems, especially those that conv

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd