Difference among the communication and transmission, Computer Networking

Assignment Help:

Difference among the communication and transmission.

Transmission is a physical movement of information and concern issues like bit polarity, synchronisation, clock etc.

Communication means the meaning full exchange of information among two communication media.

 


Related Discussions:- Difference among the communication and transmission

Control - transport layer, Control This field  defines 6 different  co...

Control This field  defines 6 different  control  bits or  flags. These bits  enable flow  control  connection  establishment  and termination connection abortion and the mode

Output port - network layer and routing , Output Port The function of t...

Output Port The function of the  port is  take  the packets that have  been stored in the out  put port  memory and transmits them over the out going  link. The queuing  and bu

Explain about twisted-pair cable, Q. Explain about Twisted-Pair Cable? ...

Q. Explain about Twisted-Pair Cable? - Two conductors surrounded by insulating material - One wire utilize to carry signals and other used as a ground reference - Twistin

Define what is interior and exterior routing protocol, Can you define what ...

Can you define what is interior and exterior routing protocols?

Introduction to operating system for parallel computer, INTRODUCTION T...

INTRODUCTION This part discusses the additional requirements at software levels and operating system which will create the parallel programs run on parallel hardware. Collecti

Explain the three principles of data communication system, Question 1 Vide...

Question 1 Videoconferencing is used to conduct meetings with the people who are located in far distance. Videoconferencing is an example of which type of computer networks? Expla

Write a descriptive note on rmonv2, Question 1 What does the SNMP access p...

Question 1 What does the SNMP access policy represent? Question 2 Does there exist any formal functional specification for SNMPv1 management? Question 3 In the con

Telecommunication switching system, if the signal input to an amplifier is ...

if the signal input to an amplifier is 0 dBm what is the power output in mW if the gain of the amplifier is 20 dB ?

Process switching and fast switching, Process Switching It applies the...

Process Switching It applies the brute force method to switch packets wih consumption of large amount of CPU time List of items are needed when switching packets Routing

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd