Determine the reactions at supported end, Mechanical Engineering

Assignment Help:

A steel dia 10 mm passes through a brass tube of internal dia 15mm and external dia is 25 mm. The bolt is tightened by a nut. The length of tube is reduced by 1.5mm and the length of tube is 1500mm. if temp. of assembly is raised by 40o . Find the axial stress in bolt and tube before and after heating. Provided that :

Es = 2 x 105 N/mm2

Eb = 1 x 105 N/mm2

s = 1.2 x 10-5 N/oC

b = 1.9 x 10-5 N/oC

(b) A prismatic bar of cross-sectional area A is subjected to axial force ‘P' at C. Determine the reactions at supported and deflection at C.


Related Discussions:- Determine the reactions at supported end

Form tool, detals of type of form tool?

detals of type of form tool?

Find the out value of force - cantilever truss, A cantilever truss is loade...

A cantilever truss is loaded and supported as shown in the figure given below. Find the out value of P , which would produce an axial force of magnitude 3KN in member AC .

What are the causes of high fuel consumption, (a) What are the causes of hi...

(a) What are the causes of high fuel consumption? (b) How can the problem of "motorcycle pulls to one side" be corrected? (c) How can engine overheating problem be solved?

Show general properties of castings, Q. Show General Properties of Castings...

Q. Show General Properties of Castings? 1. Fe-Cr (10-30%Cr) alloys offer good resistance to oxidation, low strength at elevated temps, restricted to use in oxidizing or reducin

Ease of operation-factors in clutch design , Ease of Operation : For highe...

Ease of Operation : For higher power transmissions, the operation of disengaging the clutch must not be tiresome to the driver.

Define and classified parallel forces, Define and classified parallel force...

Define and classified parallel forces Sol.: The forces, the lines of action of which are parallel to each other, are called as parallel forces. They do not meet at one point

Projection welding, Projection Welding Projection welding is similar to...

Projection Welding Projection welding is similar to spot welding but for the fact that the welding takes place at the projections on the surface of the metals and flat shaped e

High growth for automobiles industry growth , High growth has been observe...

High growth has been observed since 2001-02 in automobile production. Annual growth was 16.0 percent in April-December, 2004; the growth rate in 2003-04 was 15.1 percent (Table 1.

What is ifc in project management, Q. What is IFC in project management? ...

Q. What is IFC in project management? This revision is to be used as a basis for preparing detailed design for final checking of IFC drawings by other disciplines, for incorpo

Find the location of the centroid, Find the Location of the Centroid a...

Find the Location of the Centroid a)  Write the integrals for the determination of the location of the centroid of the area shown in Figure-(a).  Only set up the integral.

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd