Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
An open belt connects two flat pulleys. The pulley diameters are 300 mm and 450 mm and the corresponding angles of Cap are 160o and 210o.
The smaller pulley runs at 200 r.p.m. The coefficient of friction between the pulley and belt is 0.25. It is taken that the belt is on the point of slipping when 3 KW is transmitted. To gain the power transmitted two alternatives are suggested, namely
(i) increasing the coefficient of friction by 10% by the application of a suitable dressing to the belt and
(ii) increasing the initial tension by 10%.
Which of these two process would be more effective ? Determine the percentage increase in power possible in each case.
Estimate the Machining Time A hollow workpiece of 60 mm outside diameter and 150 mm length is held on a mandrel among centers and turned all over in 4 passes. If the approach
hardness of bore well water is less than sea water .justify
what is the practical application of worm and worm gear
Simply supported beam - Bending Moment: Sketch the SFD and BMD for a simply supported beam of 15 m span loaded as illustrated in Figure Figure Solution Tak
Used Engine Oil: Used engine oil may cause skin disease if repeatedly in contact with the skin for prolonged time. It is advisable to thoroughly wash the hands with soap and water
Q. Inspection and testing for coating application? The Applicator shall perform all inspection and testing necessary to assure that the surface preparation and coating applicat
I have done Bca in 2012 persuing Doing job which is not stable i have to learn automobile design and mechanism and restoration finding some iti course
Types of stresses: In general stress is divided in to three group as: various types of stresses may be classified as: 1. Simple or direct stress (Tension, Compressi
Q. Explain Double Bolting? Where low strength bolts must be used, initial bolting with higher strength low temperature bolts may be necessary to minimize accumulative strain an
Determine time required to stop the automobile: A 20KN automobile is moving at speed of 70Kmph when brakes are fully applied causing all the four wheels to skid. Determine ti
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd