Determine the equivalent impedance, Electrical Engineering

Assignment Help:

Q. A 75-kVA, 230/115-V, 60-Hz transformer was tested with these results:

• Open-circuit test: 115 V, 16.3 A, 750 W

• Short-circuit test: 9.5 V, 326 A, 1200 W

Determine:

(a) The equivalent impedance in high-voltage terms.

(b) The voltage regulation at rated load, 0.8 power factor lagging.

(c) The efficiency at rated load, 0.8 power factor lagging, and at half-load, unity power factor.

(d) The maximum efficiency and the current at which it occurs.


Related Discussions:- Determine the equivalent impedance

#t voice controlled mobile base, The aim of this project is to design, co...

The aim of this project is to design, construct and build a motorised base driven by two small dc motors. The motor drives are two H-bridges. The switching devices in these bridges

Obtain the sop expression, Q. Given the K map of a logic function as shown ...

Q. Given the K map of a logic function as shown in Figure, in which ds denote don't-care conditions, obtain the SOP expression.

Determine the signal bandwidth and the amplitudes, Determine the signal ban...

Determine the signal bandwidth and the amplitudes, Computer Networking

Determine the minimum number of poles for the motor, Q. From a three-phase,...

Q. From a three-phase, 60-Hz system, through a motor-generator set consisting of two directly coupled synchronous machines, electric power is supplied to a three-phase, 50-Hz syste

Magnet, Magnetic materials

Magnetic materials

Cpld design project, 1) Study the CPLD Design Project Brief to gain an unde...

1) Study the CPLD Design Project Brief to gain an understanding of the project, and the System Specification, Circuit Description, Pre-processing and Post-processing Requirements f

What are the various types of amplifiers, Q. What are the various types of ...

Q. What are the various types of amplifiers? Amplifiers can be classified as follows: (a) Based on the transistor configuration 1. Common emitter amplifier 2. Common c

Power flow analysis, Ask question #Minimum 10] In the system shown in Fig...

Ask question #Minimum 10] In the system shown in Figure 4-1, the rated voltage of the line is 110kv, and the conductors are all LGJ-120 type. The parameters are: r1=0.21O/km,x1=0

What do you understand by solid modeling, What do you understand by solid m...

What do you understand by solid modeling and wireframe modeling in CAD systems? Explain and compare the both modellings. Describe the following 1. Boundary representation 2.

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd